Pump Rotor
(Procedure if rotor is binding)
1. | Remove upper shell (see |
| page 10). |
2. | Remove filter end cover |
| screws using 5/16" nut- |
| driver. |
3. | Remove filter end cover |
| and air filters. |
4. | Remove pump plate |
| screws using 5/16" nut- |
| driver. |
5. | Remove pump plate. |
6. | Remove rotor, insert, and |
Blade
Air
Pump Intake
Plate Filter
Filter End
Cover
Fan Guard (26,4
kW [90,000 Btu/
Hr] Model Shown)
Insert
Rotor
Air Output
Filter
Figure 31 - Rotor Location, 8,8/20,5 kW (30/70,000 Btu/Hr) Models
| blades. |
7. | Check for debris in pump. |
| If debris is found, blow |
| out with compressed air. |
8. | Install insert and rotor. |
9. | Check gap on rotor. |
| Adjust to .003"/.004" |
| (.076/.101 mm) if needed |
| (see Figure 33). |
Note: Rotate rotor one full turn to insure the gap is
.003"/.004" (.076/.101 mm) at tightest position. Adjust if needed.
Blade
Insert
Rotor
Air
Output
Filter
Pump
Plate
Air
Intake
Filter
Filter End
Cover
Fan Guard
(26,4 kW [90,000 Btu/ Hr] Model Shown)
10.Install blades, pump plate, air filters, and filter end cover.
11.Replace fan guard and upper shell.
12.Adjust pump pressure (see page 14).
Note: If rotor is still binding, proceed as follows.
13.Perform steps 1 thru 6 above.
14.Place fine grade sandpaper (600 grit) on flat surface. Sand rotor lightly in “figure 8” motion four times (see Figure 34).
15.Reinstall insert and rotor.
16.Perform steps 10 thru 12 above.
18
Figure 32 - Rotor Location, 26,4/44 kW (90/150,000 Btu/Hr) Models
Gap Adjusting
Screw
.003"/.004" (.076/.101 mm) Gap Measured With
Feeler Gauge
Sandpaper
Blade | Rotor |
Gap
Adjusting
Screw
Figure 33 - Gap Adjusting |
|
Screw Locations | Figure 34 - Sanding Rotor |
099623