EdgeStar AP410W manual

		The air intake or exhaust ports
		are partially obstructed.		Remove the obstruction.
				Vacuum the air inlet located
		The condenser coils are dirty		on the side of the unit
				Move the unit to another
The control panel lights		The unit has a minor electrical		circuit or unplug the unit and
		fault		plug it in again.
are blinking randomly		The unit is plugged into an		Move the unit to another
		outlet that cannot supply the		circuit or unplug the unit and
		correct electricity to the unit		plug it in again.
				The drain pan has no auto
				shut-off- do not leave the unit
				unattended while draining into
				an external drain pan- the
The unit is leaking		The unit is draining into the		level of water in this drain pan
		drain pan		must be manually monitored
		The drain stopple and plug are		Install the stopple and drain
		not installed		plug
		The unit is not on a level		Make sure the unit is on a
		surface		level surface
The air conditioner is too		The unit is positioned on a
loud.
		hard, uneven floor, and is		Move the unit onto a level,
		vibrating.		carpeted surface.
The Run LED is blinking
and the air conditioner is		The internal water reservoir is
beeping.		full.	Drain the water reservoir.
The LED display seems to				Turn the unit on with the
show that the air
conditioner is on, but it is		The "Timer on" feature is		power button to deactivate the
not working.		activated.		"Timer on" feature.
"E1" shows in the LED		The evaporator sensor has
display.		detected a problem.		Contact customer service.
"E2" shows in the LED		The room temperature sensor
display.		has detected a fault.		Contact customer service.
"E5" shows in the LED		The overheating protection
display.		sensor has detected a fault.		Contact customer service.
"E7" shows in the LED
display.	The water reservoir is full.			Drain the water reservoir.
	21