EdgeStar AP10002BL owner manual Important Safety Information, Electrical Safety, General Safety

Page 2

Important Safety Information

Improper handling can cause serious damage to the appliance and/or to the user. Please read the following safety information.

Electrical Safety

This unit is designed for indoor use only.

Do not use the unit in extremely humid or wet environments.

Do not spray water and wet the housing or control panel.

Do not pull the unit by the cord.

Always turn the unit off and unplug it from the outlet when cleaning.

Unplug the unit if it is not going to be used for a long period of time.

Do not operate the unit with a damaged plug or a loose socket.

Use only the correct power supply with appropriate amperage.

If the power cord is damaged, it must be replaced by the manufacturer, a service agent, or qualified technician.

Do not remove any part of the casing unless instructed by an authorized technician.

General Safety

This portable air conditioner is not intended to be used by children.

Children should be supervised to ensure that they do not play with this product.

Do not allow children to play with the controls or drop any objects into the air outlets or vents.

Do not place objects or let any person sit on top of the unit.

Only use in the upright position on a flat, level surface and provide at least 20 inches of clearance from any walls or objects.

Route the power cord carefully to avoid a tripping hazard.

This unit is intended for domestic use only. Do not use the portable air conditioner for industrial or commercial use. Any other use may invalidate the warranty.

RESET

TEST

Your portable air conditioner is supplied with a Leakage-Current Detection and Interruption (LCDI) safety plug. This device provides protection to reduce the risk of fire due to arcing faults in the power supply cord. Before using your portable air conditioner, follow the instructions below to ensure that the LCDI plug is working properly:

1.Plug the power cord to a grounded outlet.

2.Press the TEST button on the LCDI plug. This should trip the plug and cut the power to the air conditioner. If the plug does not trip and you are able to turn on the unit, please contact EdgeStar support.

DO NOT USE YOUR PORTABLE AIR CONDITIONER IF THE TEST FAILS.

Press the RESET button to start using your air conditioner.

Do not use the TEST and RESET buttons as an ON/OFF switch.

Electrical products should not be disposed of with household waste. Please contact your local recycling center for more information on how to recycle electronic waste.

i

Image 2
Contents AP10002BL General Safety Important Safety InformationElectrical Safety Table of Contents Introduction For Your RecordsParts Identification Parts KeyPreparations for installing the window kit Parts IncludedWindow Kit Installation Instructions Attach the window panel to Installation of the Exhaust Hose Page Installation of the Drain Hose Draining the Unit Direct drainageInstalling the Filter Operating Instructions Control Panel OverviewDirectional Louvers Remote Control Overview Button FunctionFan Only Mode Installing the batteriesCooling Mode Energy Saving Guide SleepCleaning the pre-filter MaintenanceCleaning the unit Preparation for Storage Troubleshooting Issue Possible Cause SolutionIssue Possible Cause Solution Issue Possible Cause Solution Specifications EdgeStar Limited Warranty One 1 Year Parts & Ninety 90 Days Labor