EdgeStar AP10002BL owner manual Issue Possible Cause Solution

Issue	Possible Cause	Solution
My air conditioner is	Unit is not operating in	Set the unit to be in
not cooling at all.	cooling mode.	cooling mode, and
		lower the set
		temperature (pg. 13).
	The compressor is not	The compressor may
	on.	take up to 3 minutes to
		turn on, or longer if it is
		too warm.
	The ambient	Lower the room
	temperature is too	temperature to be
	high.	below 90°F degrees.
	The filter may be dusty	Clean the filters.
	or blocked.	(pg. 16)
	Blocked exhaust port.	Remove any
		obstructions in the
		exhaust hose and port.
My air conditioner	The unit is not vented.	The unit must be
blows cold air, but		vented. (pg. 4)
does not lower the	The area of the room	Minimize the size of
room temperature.	is too large.	the area to be cooled,
		i.e. adding a drop
		ceiling. Use more than
		one unit to cool the
		area, or use a larger
		unit.
	Open windows and	Close any open doors
	doors.	and windows.
	Too many heat	Remove or shut off
	sources.	additional heat
		sources such as radio
		equipment, servers,
		etc.
	The room/garage may	Properly insulate the
	be inadequately	room to be cooled, i.e.
	insulated.	using fiberglass.
	The ambient	The unit may not work
	temperature is too	if the room
	high.	temperature is above
		90°F.
	Direct sunlight is	Close curtains or pull
	heating the room.	down blinds, and
		minimize the direct
		sunlight into the room.
	The filter may be dusty	Clean the filter and
	or blocked.	replace it if needed.
	Dirty condenser coils.	Carefully vacuum the
		coils clean.
	Obstructed air intake	Remove anything
	or exhaust ports.	blocking the ports.

Edgestar Portable Air Conditioner 18