EdgeStar AP10002BL owner manual Troubleshooting, Issue Possible Cause Solution

Page 20

Troubleshooting

Follow the troubleshooting guide below to resolve common issues.

Issue

Possible Cause

Solution

My air conditioner is

Unit is not receiving

Make sure the unit is

not functioning at all.

power.

plugged in to a

 

 

grounded outlet.

 

LCDI power cord is

Press the Reset button

 

tripped.

on the LCDI cord.

 

Insufficient power.

Move the unit to

 

 

another outlet. Check

 

 

your circuit breaker.

 

 

(Refer to the rating

 

 

label on the back of

 

 

the unit to determine

 

 

the Amperage draw).

 

Water reservoir is full.

Drain the unit and

 

 

restart.

 

Control panel is

If no indicator lights

 

disconnected.

turn on, contact

 

 

customer service.

My remote control

Batteries not installed.

Install new batteries.

does not work and the

Bad batteries.

Replace the batteries.

indicator light on

Batteries installed

Reinstall the batteries

remote does not turn

incorrectly.

correctly.

on.

A defective remote

Contact customer

 

control.

service.

My air conditioner is

The unit is not level.

Make sure the unit is

making a loud noise.

 

on a level surface.

 

A foreign object has

Remove the object

 

jammed the fan.

from the fan.

 

The floor below the

Move the unit to a

 

unit is uneven.

level surface.

My air conditioner is

Unit may have been

Shut off the unit. Let

making a continuous

shipped on its side.

the unit sit on a level

metallic knocking or

 

surface for at least 24

pinging sound.

 

hours and restart.

 

Damaged compressor.

Contact customer

 

 

service.

My air conditioner is

Drain plug is removed.

Attach the drain plug.

leaking.

Cracked base pan.

Contact customer

 

 

service.

My air conditioner runs

The air conditioner

Contact an electrician

for a little while and

may be plugged into

if the unit works in a

then it trips the power

an outlet that can not

different room or

cord or the circuit

supply the correct

circuit.

breaker.

amount of current.

 

The control panel

Unit may have a faulty

Contact customer

lights blink randomly.

control panel.

service.

No air comes out the

The unit is designed to

This is normal

left side of the air vent.

blow air from the right.

operation.

17

Image 20
Contents AP10002BL General Safety Important Safety InformationElectrical Safety Table of Contents Introduction For Your RecordsParts Identification Parts KeyPreparations for installing the window kit Parts IncludedWindow Kit Installation Instructions Attach the window panel to Installation of the Exhaust Hose Page Installation of the Drain Hose Draining the Unit Direct drainageInstalling the Filter Operating Instructions Control Panel OverviewDirectional Louvers Remote Control Overview Button FunctionFan Only Mode Installing the batteriesCooling Mode Energy Saving Guide SleepCleaning the pre-filter MaintenanceCleaning the unit Preparation for Storage Troubleshooting Issue Possible Cause SolutionIssue Possible Cause Solution Issue Possible Cause Solution Specifications EdgeStar Limited Warranty One 1 Year Parts & Ninety 90 Days Labor