Oreck 4000, 9000, 3000, 2000 Parts List, Assembly, Operating Instructions, General Information

E N G L I S H

Parts List

Two-Speed Helping Hand® Handle: Press the On-High (ll) - On-Low (l)

-OFF(O) switch on handle assembly when ready to operate.

To assist you in identifying components of your vacuum, the parts have been numbered as follows:

1	Handle section, upper	8	Bag tension bar
2	Tube, lower	9	Zip fastener
3	Power head	10	On/off switch
4	Outer bag	11	Cord hook
5	Paper filter dust bag	12	Plastic loop/cable clamp
6	Power cord	13	Connector assembly
7	Retaining spring	14	Fan housing
		15	Cord assembly
9000 Series Parts Only

16Buttons

17Rubber Collars

Switch On Base: Press the On (l) - OFF (O) switch on top of base when ready to operate.

Up-Position Lock

fig. 4 Place foot on power head and lean handle back gently to release lock for vacuum use. Return handle to the full upright position to engage lock.

NOTE: Do not operate the unit while in the upright and locked position. Do not let the unit run while in any one stationary position for any period of time. Keep the unit moving while in operation.

For Easy Power Cord Storage

fig. 5 Wrap power cord around cord hook on handle and cord hook on connector. Secure to "U" shaped part on plug.

Operating Recommendations

Straight Handle w/o Light				Helping Hand® Handle w/Light			This ORECK XL High-Speed Upright is one of the finest, fastest, and
			17
				10			strongest units in its class. You’ll love the way it cleans, gets under
			16				things, and it’s SO lightweight and easy to use.
		9				11
				9	1		The following are a few simple suggestions regarding its operation:
		1	11		12		1.	When inserting a new disposable paper filter dust bag—FIRST
5								PUFF OUT and OPEN THE BAG.
							2.	When the disposable filter dust bag is full, REPLACE IT.
			16				3.	If at any time the machine does not pick up properly or makes an
	4	12	17	5	13			unusual noise, STOP OPERATION and service.
		2		4			4.	Although your upright will pick up pins, paper clips, and other small
								objects, it is recommended that these be removed from the floor
					2
			6				6	before you vacuum. Failure to do so may result in permanent
								damage to the motor suction fan and its housing.
		7 10
			14				5.	WARNING: Do not use your vacuum cleaner on damp or wet
	8			8 7	14	15		surfaces. This will cause damage to the vacuum cleaner and is
								dangerous to the user. Damage caused by use on wet or damp
								surfaces is not covered under warranty.
		3					6.	REPLACE THE BELT EVERY 6 MONTHS.

3

3000 & 4000 Series Power Head

3

Assembly

fig. 1 Before assembling appliance, remove two screws from connector assembly. If cardboard insert present then, remove insert by pulling upward.

fig. 2 Slide upper handle section over	Handle
matching section of the connector	Plug
assembly. Insert short screw into top
hole and long screw into the bottom
hole then tighten firmly until handle is
no longer loose. For units with a
handle plug, insert plug on cord
assembly into handle. Machine should
be in upright position when inserting
cord assembly into handle.

fig. 3 Attached cord to cord clip by pressing above and below clip ensuring the cord is fully rested in clip. (Note: Some units come with an enclosed cord clip that is already assembled.)

Operating Instructions

7.Change the disposable filter dust bag at least once a month—even if it is not full! The collected dust in the dust bag can cause odor, attract moisture, and can affect the efficiency of the cleaner.

8.DO NOT run the vacuum cleaner over the cord. The revolving brush could damage the cord.

9.Use caution when vacuuming over area rug edges and fringe.

General Information

The performance of your cleaner greatly depends upon care and mainte- nance. The instructions in this manual will guide you in performing basic care and maintenance. To obtain the most satisfying years of service read the instructions and keep them handy for future reference.

Disposable Paper Filter Dust Bags

Disposable paper filter dust bags play a very important role in the efficiency of your ORECK vacuum cleaner. The purpose of the paper bag is to trap dirt, but at the same time it must be porous enough to allow air to pass through. If the paper bag becomes clogged, no air can pass through the cleaner and cleaning cannot take place, regardless of the cleaner’s power.

To keep your cleaner operating at maximum efficiency, change the dust bag frequently. DO NOT FILL ABOVE THE LINE INDICATED ON THE

DUST BAG.

Be sure the disposable paper filter dust bag is installed properly.

Make sure disposable paper filter dust bag is in place. DO NOT operate the cleaner without a paper filter dust bag. Plug the power cord into an electrical outlet.

Single-Speed Helping Hand® Handle: Press the On(l) - OFF(O) switch on handle assembly when ready to operate.

All paper dust bags are not the same. Your ORECK disposable dust bags have been designed to be used with the ORECK cleaner. Using bags other than genuine ORECK TYPE CC disposable bags will affect the cleaning ability of your cleaner and could cause damage to it.

4