Oreck 2000, 9000, 4000, 3000 warranty Bulb Replacement, Stuffing or Blockage

Page 7

E N G L I S H

Bulb Replacement

WARNING: Unplug cord from electrical outlet before servicing.

fig. 23 Remove lamp housing by removing two (2) screws in the top of the lamp housing. Pull burned out bulb from holder and replace with new bulb. Use only Oreck replacement parts. Replace lamp housing by replacing two screws in the top of the lamp housing.

Stuffing or Blockage

IMPORTANT: On plush and new carpets, stuffing may occur inside the the intake tube and the lower tube assembly. This is due to excessive fuzz and loose cuttings in the carpet. Stuffing could occur for the first few cleanings until all the loose material is removed. Due to the high efficiency of the cleaner, many older carpets will cause stuffing when the cleaner is first used on them. If your vacuum cleaner does not pick up properly, or makes unusual noise and the outer bag does not fluff up or balloon open, follow these steps:

WARNING: Unplug cord from electrical outlet before servicing.

fig. 24 Check for blockage at the mouth of the intake opening. If there is blockage, remove it with long-nose pliers, a screwdriver or wire coat hanger. If you can not reach the blockage, remove baseplate (fig. 25).

fig. 26 If the blockage is not at the base, remove lower tube. Unhook retainer spring, releasing bottom of bag.

Twist lower collar counterclockwise to slide up. Pull tube out of base.

fig. 27 2000 Series: If set screw is present, loosen set screw in lower collar.

fig. 28 9000 Series: Pull rubber collar over plastic tabs on fan housing, press metal button to release tube. Twist lower tube and pull apart.

fig. 29 Check for blockage. If blockage is in the tube, remove with a coat hanger.

fig. 30 If tube is not blocked, look into fan housing. Remove debris

with long-nose pliers, a screwdriver or coat hanger.

fig. 31 To reassemble, check O-ring on tube, and replace if damaged. Vacuum will not operate properly without the tube O-ring. Slide O-ring to approximately 2" from base of tube. Replace tube by first lining up slot at base of tube with inner tab inside fan housing. Then reinsert tube and push down until the tube is seated. Make sure O-ring is in place against fan housing opening. Replace and tighten collar until collar locking tabs are locked in place.

fig. 28 9000 Series: Place tube in fan housing opening, turn tube until buttons snap into button holes. Slide collars in position, over plastic tabs on fan housing. Make sure plastic tabs are inserted in collar holes.

fig. 32 Make sure collar is not cross threaded on housing. Reattach bag spring (fig. 26).

fig. 33 Many times blockage occurs due to a full dust bag causing dirt to

back down the air flow system. When that happens, the blockage will be at the top of the system, starting in the area where the dust bag connects to the connector assembly.

NOTE: If the above actions do not correct the problem, contact an Oreck authorized service center or call the customer service center.

U.S.: 1-800-989-3535 Canada: 1-888-676-7325

S I M P LY A M A Z I N G ®

GUIDE D’UTILISATION

F R A N Ç A I S

9000

2000

3000

4000

VIDES DE SÉRIE

ASPIRATEUR VERTICAL RAPIDE

A VEC SYSTÉME DE NETTOYAGE

®

•IMPORTANT•

CONSERVEZ CE FASCICULE

Comprend:

Avertissements de sécurité

Garantie

Mode d’emploi

Guide de dépannage

Accessoires

6

Page 6 Page 8
Image 7
Page 6 Page 8
Contents 9000 2000 3000 4000 OLD Polarized Plug Notice Table of ContentsMaintenance and Customer Service Accessories Sold SeparatelyTroubleshooting Guide WarrantyGeneral Information Parts ListAssembly Operating InstructionsTo Replace Filter Dust Bag How to Replace a Worn BeltTo Adjust or Replace Brush Using An Oreck Fresh Air TabStuffing or Blockage Bulb ReplacementAvis de fiche polarisée Entretien et service à la clientèleAccessoires Vendu Séparément Table des matièresGuide de dépannage GarantieInformations générales Mode d’emploiListe de pièces AssemblageRemplacement d’une courroie usée Remplacement du sac à poussières filtrantRéglage ou remplacement du balai Utilisation d’une tablette Oreck Fresh Air Remplacement de l’ampoule électriqueBlocage ou bourrage Accesorios Vendido por separado IndiceMantenimiento y servicio a clientes Aviso de la clavija polarizadaGarantía DE SeguridadSerie 9000 Solamente Guía para identificación de problemasLista de piezas EnsamblajeInformación general Instrucciones de operaciónUso de una tableta Oreck Fresh Air Para reemplazar la bolsa para polvo de filtroCómo reemplazar una correa desgastada Para ajustar o reemplazar el cepilloP a Ñ O L Oreck XL Housekeeper Compact Canister Vacuum Telephone Signature City State

2000, 3000, 4000, 9000 specifications

Oreck vacuum cleaners have been known for their lightweight design and powerful performance. Among their popular models are the Oreck 3000, 4000, 9000, and 2000. Each model offers unique features and technologies tailored to meet varying cleaning needs and preferences.

The Oreck 3000 is designed for those seeking a reliable, easy-to-use vacuum. It features a powerful, yet lightweight motor that allows for effortless maneuvering around the home. The 3000 is equipped with a two-speed motor, enabling users to switch between a low setting for delicate surfaces and a high setting for deep cleaning carpets. Its proprietary HEPA filter traps 99.97% of dust and allergens, promoting better air quality within the home.

Moving to the Oreck 4000, this model enhances the cleaning experience with additional features focused on pet owners. The 4000 comes with specialized brushes and a reinforced belt designed to capture pet hair effectively. Its extended reach hose and onboard tools such as crevice tools and upholstery brushes make it versatile for cleaning hard-to-reach areas. Furthermore, the 4000 boasts a continuous suction technology that ensures minimal loss of power even when the dustbin is filling up.

The Oreck 9000 takes things to another level with its advanced dual filtration system. This model is perfect for allergy sufferers, as it includes both a HEPA filter and a secondary charcoal filter to neutralize odors while capturing dust and allergens. The 9000 incorporates Smart Technology, which automatically adjusts the suction power based on the type of flooring being cleaned—carpet or hard floor. This intelligent feature helps preserve battery life and provides optimal cleaning performance.

Finally, the Oreck 2000 is tailored for users looking for a compact and efficient vacuum without compromising on performance. Its lightweight design and slim profile make it easy to store and transport. The 2000 features a powerful dual motor system that provides strong suction power while being energy-efficient. Its quick-release cord and integrated dustpan make disposal and maintenance a breeze.

In summary, Oreck’s range of vacuum cleaners, including the 3000, 4000, 9000, and 2000, showcases a commitment to innovative cleaning solutions with a focus on user-friendliness. Each model is designed with modern technologies that cater to various cleaning requirements, ensuring efficient and thorough cleaning for all surfaces while maintaining excellent air quality in the home.
Top Page Image Contents