E N G L I S H
To Operate
Plug cord into electrical outlet.
Power Switch | ON/OFF | |
| ||
Push power switch to | SWITCH | |
“ON” (I) position. |
| |
Shoulder Strap |
| |
Insert end of | STRAP | |
shoulder strap into | ||
SLOTS | ||
slot in front of on/off | ||
| ||
power switch. Pull |
|
through three to four inches and insert into plastic clip. One inch of strap must be completely through clip. Insert other end of strap through slot located at back of handle. Insert end into clip and pull through. Adjust length by pulling strap through clip. Strap must go through both front and back clips.
IMPORTANT: Before using shoulder strap, pull both ends to be sure it is secure.
Hose & Tool Installation
To Operate
Cord Dump
Twist cord dump to easily release stored cord.
Assembly
Attach Caddy and Insert Tools
Locate caddy clip indents at top rear corners of appliance. Place appliance on firm,
other end of caddy into opposite indent. Be sure rims
The wands and cleaning tools supplied with your ORECK XL compact vacuum lock together with friction. Twist and push to be sure they lock tightly when installing. Twist and pull to remove.
Twist and push to install tools.
Twist and pull to remove tools.
on caddy openings face up. Avoid trapping fingers when caddy snaps on; painful pinch could result. If caddy needs to be removed, a large
Pull cord through center opening in caddy and push until it is seated at back of slot at rear of center opening in caddy.
NOTE:
When installing tools directly to blower or suction port without using hose, tool adapter tube must be used.
ADAPTER TUBE
Insert crevice tool, brush and fabric tool into caddy in spaces provided.
Blower Port |
| |
BLOWER | ||
The blower port is | ||
PORT | ||
located at the rear |
| |
of the machine. |
| |
Installation of tools |
| |
is the same as |
| |
described for suction |
| |
port. |
| |
|
|
4