Heatiator GC150 owner manual VII. Maintenance Instructions

GC150 SERIES DIRECT VENT GAS APPLIANCE

VII. MAINTENANCE INSTRUCTIONS

Cleaning the burner and control compartment

Keep the burner and control compartment clean by brushing and vacuuming at least once a year. Always turn off the gas valve and the ON/OFF switch before cleaning.

Checking flame patterns

Visually check the flame of the burner periodically, making sure the flames are steady; not lifting or floating. The flame color should be blue with yellow tips. The ignitor (electronic) or thermopile (stand- ing pilot) tips should be covered with flame. See Figures 41 through 44.

Venting system inspection

The appliance and venting system should be inspected before use, and at least annually, by a qualified field service person, to ensure that the flow of combustion and ventilation air is not obstructed.

Cleaning the glass

Note: When cleaning the glass, NEVER use abrasive materials. NEVER clean glass when hot. Keep pets and children a safe distance away.

It is recommended to wear gloves while handling or removing glass. DO NOT REMOVE GLASS WHEN HOT.

Clean glass after initial one hour burn. This is to remove any film that develops from oils and log burn in time. After initial cleaning, clean as needed.

To remove the glass for cleaning, follow Step 11 on page 16. Handle glass panel with care to avoid striking or scratching it on hard objects.

To clean the glass, use a non-abrasive automotive rubbing com- pound and glass cleaner. Simply apply an adequate amount to the glass and wipe off per manufacturers instructions. Contact your local stove shop or fireplace accessaries store for further rec- ommendations.

Never operate this appliance without the glass properly secured in place or if the glass is broken.

In the event of glass breakage, follow glass removal instructions to remove the top retaining strip. Remove lower retaining strip in the same manner. This will allow the removal of all glass frag- ments and sheet metal edge protection strips. Vacuum all remaining glass pieces with a shop vac. (DO NOT VACUUM IF PIECES ARE HOT.) Replace glass only with Heatilator part num- ber 15573 ordered direct or through your local distributor. Never use substitute material. Only fully tempered soda lime safety glass or optional ceramic glass may be used on this appliance.

Log cleaning

Logs can be easily lifted out of position. Carbon build-up can be removed with a vacuum cleaner.

To prevent the possibility of soot, we have provided your fireplace with an adjustable air shutter. Your air shutter is provided in an open position to ensure clean operation under normal situations. In the even that soot is accumulating in your appliance, the air shutter should be opened farther as shown in Figure 44. This can be done with a screwdriver or a 1/4” wrench. Also, ensure logs are positioned correctly to minimize flame contact with the logs.

Figure 41

Electronic Ignition

Figure 42

Electronic Ignition

Figure 43

Standing Pilot

Figure 44

Both Ignitions

12-98 24 21322K