Heatiator owner manual VIII. Trouble Shooting, Electronic Ignition GC150E

Page 25

GC150 SERIES DIRECT VENT GAS APPLIANCE

VIII. TROUBLE SHOOTING

ELECTRONIC IGNITION (GC150E)

Problem

1.Spark ignitor will not light burner after repeated attempts.

2.Burner will not stay lit.

3.With valve and wall switch in “ON” position, no gas to burner.

4.Glass doors fog up.

5.Blue flames.

Cause

A.Defective ignitor; loose wire.

B.Misaligned electrode at ignitor.

A.Defective ignitor.

B.No ground.

A. Manual on/off valve(s) shut off.

B.Plugged burner orifice.

C.Wall switch defective.

D.No Power

A.A normal result of gas combustion.

A.A normal result during the first 20 minutes of burning.

Corrective Action

Check for loose connections on electrode and ignitor. Refer to the wiring diagram on page 13 for assistance.

Check for spark. If electrode connection is correct and there is no spark, replace ignitor.

Spark should be extending approx. 3/16" to ground wire. See Figure 42. Adjust gap to give proper spark. Remove hands from electrode before attempting.

Check burner flame. See Figure 41. Adjust ignitor if neces- sary.

Be sure ignitor is secured tight into bracket and bracket is secured tightly to the unit.

Be sure wiring connections are tight throughout system, including high limit switch.

Check that wiring is grounded as shown in Figure 19.

Check all gas valves leading to appliance. Turn to the “ON” position. Check for 24 volt power off secondary on the trans- former.

Check burner orifice; remove blockage.

Check continuity.

Check 110VAC supply (Fuses/Breaker)

No action is necessary. After the fireplace has warmed up, the glass will clear.

No action is necessary. Flames will begin to turn more yel- lowish after about 20 minutes of burning. If blue flames per- sist, check air shutter setting and check log and embers are positioned correctly.

B. Improper air mixture.

Check air shutter setting.

4-99

25

21322M

Image 25
Contents Models GC150, GC150L, GC150E, GC150LE Table of Contents II. Description of the Fireplace System Listings and Code ApprovalsCatalog Number Description III. Fireplace System ComponentsRoof Flashing Wall ShieldFirestop Spacer Vertical Termination Cap EL45 Vent SectionsFireplace Locations and Clearances IV. PRE-INSTALLATION PreparationFinishing Materials Framing the FireplaceTermination Nailing Flanges Positioning the FireboxGC150 Series Direct Vent GAS Appliance Cm minimum Horizontal Termination Cap Locations Dimension DescriptionsVertical Termination GC150 Series Direct Vent GAS Appliance Venting System Termination Height Gas line installationDouble Checking Gas LineLower Panel Removal Electronic Ignition Wiring DiagramStanding Pilot Ignition Standing Pilot Ignition Wiring DiagramAttaching Hood Hood PlacementFinishing Location of PanelsArranging the Logs Positioning the Logs Positioning the LogsPlacing the Rock Wool Glass Replacement Screen Replacement Glass ReplacementLower Panel Replacement Replacing the PanelsVI. Operating Instructions Standing Pilot Ignition Determining the Ignition TypeLower Panel Removal Standing Pilot Operation Side View of Panel Lower Front Face ReplacementVII. Maintenance Instructions Electronic Ignition GC150E VIII. Trouble ShootingStanding Pilot Electronic Ignition GC150E IX. Replacement PartsAppliance Installer

GC150 specifications

The Heatiator GC150 is an innovative heating solution designed to provide efficient warmth in various residential and commercial settings. With an emphasis on technology and user experience, the GC150 combines modern features with powerful performance. Its sleek design fits harmoniously into different interior styles, making it a beautiful addition to any space.

One of the standout features of the Heatiator GC150 is its advanced heating technology. The unit utilizes a highly efficient heating element that quickly warms up a room while minimizing energy consumption. This energy-efficient operation not only helps reduce utility bills but also promotes a more sustainable approach to heating. The GC150 is equipped with a programmable thermostat, allowing users to set their desired temperature and optimize energy usage based on personal schedules.

The Heatiator GC150 also boasts a rapid heating capability, ensuring that it delivers consistent warmth even in large areas. This is achieved through its convection heating design, which circulates warm air evenly throughout the room. The result is a comfortable, balanced environment without cold spots or drafts.

Safety features are another significant aspect of the Heatiator GC150. The unit includes an overheating protection mechanism that automatically shuts off the device if it reaches an unsafe temperature. Additionally, the GC150 is designed with a sturdy, cool-touch exterior, preventing burns or accidental injuries, making it suitable for homes with children or pets.

Another important characteristic of the GC150 is its quiet operation. Unlike traditional heating units that can be noisy, the Heatiator GC150 runs silently, allowing for an undisturbed environment. This is particularly beneficial for bedrooms, offices, or other spaces where concentration and relaxation are essential.

Ease of use is prioritized with the Heatiator GC150, featuring user-friendly controls and an informative digital display. Users can effortlessly navigate through various settings, select heat levels, and adjust timers for convenient operation.

In summary, the Heatiator GC150 is a versatile and efficient heating solution that offers a blend of innovation, safety, and user convenience. Its advanced features, such as programmable thermostats, rapid heating capabilities, and quiet operation, make it a worthwhile investment for any setting, ensuring comfort throughout the colder months without compromising energy efficiency.