4.Rotate the mounting plate so the wire path is on the upper right. Note: The wire path on the mounting plate must be located as shown below to allow the wires on the back of the fixture to pass through.
5.Reinstall the fixture mounting screws and attach the mounting plate to the junction box as shown.
Wire Path |
| Wire Path |
|
|
|
| Ground Screw |
Fixture Screws
As Shipped | Flipped and |
| Rotated |
White
LightLight
Fixture Fixture
Black |
Green |
or Bare |
Two Motion Lights
❒Twist the junction box wires and the fixture wires together as shown below. Secure with wire connectors. If you have a metal junction box, you may not need the green“pigtail”.If you are unsure about the grounding method, consult your local building code.
Connect the fixture wires to the wires in the junction box. Twist the wires together and secure with wire connectors.
WIRING
Note: All wiring should be run in accordance with the National Electrical Code through conduit or another acceptable means.
Contact a qualified electrician if there is any question as to the suitability of the system.
CAUTION: DO NOT connect the RED wire unless you want to control other lights from the motion sensor.
Recommended Grounding Method
Use a green ground “pigtail” (not provided) and twist one end together with the bare fixture wire and the box ground wire. Secure with a wire connector. Secure the other end of the “pigtail” with the GND screw on the mounting plate.
Black | Light |
| |
Green | Fixture |
| |
or Bare |
|
White |
|
| One Motion Light |
Black to black
White to white