Heath Zenith Motion Sensing Coach Lights manual Complete Installation, Testing, Maximum Range

COMPLETE THE

INSTALLATION

❒Stuff the wires into the junction box. Make sure the wires from the fixture go through the wire path, and no wires get pinched.

Slide the fixture onto the	Junction
mounting screws and	Box
tighten nuts.

❒Caulk fixture mounting surface with silicone weather sealant. You may want to wait until you have completed the tests and adjustments on page 6.

❒Install one 100 W max. light bulb.

TESTING

❒Turn on the circuit breaker and light switch.

Note: Sensor has a 1 1/2 minute warm up pe- riod before it will detect motion.When first turned on wait 1 1/2 minutes.

Note: Meets the ENERGY STAR® guidelines when DualBrite® function is off.

❒Switch the on-time to TEST position and DualBrite® switch to the OFF position.

TEST 1 5 10 MIN	OFF 3 6 DUSK TO
ON-TIME	HOUR DAWN

Avoid aiming the control at:

•Pools of water or objects that change temperature rapidly, such as heating vents and air conditioners. These heat sources could cause false triggering.

•Areas where pets or traffic may trigger the control.

•Nearbylarge,light-coloredobjectsreflect- ing daylight may trigger the shut-off feature. Do not point other lights at the sensor.

150°

6 ft.

(1.8 m)

30ft.

(9.1m)

Maximum Range	Maximum
	Coverage Angle

598-1207-01