Troubleshooting Guide

If you experience a problem with your coach light, follow this guide before returning it to

the retailer.

SYMPTOM	POSSIBLE CAUSE

Light will not	1.	Light switch is turned off.
come on.	2. Bulb is loose or burned out.
	3.	Fuse is blown or circuit breaker
		is turned off.
	4.	Daylight turn-off is in effect
		(recheck after dark).
	5.	Incorrect circuit wiring, if this
		is a new installation.
	6.	Re-aim the sensor to cover
		desired area.

Light comes on	1. Light control may be installed
in daylight.		in a relatively dark location.
	2.	Light control is in Test. (Set
		control switch to an ON-TIME
		position.)

Light comes on	1.	Light control may be sensing
for no apparent		small animals or automobile
reason.		traffic (re-aim sensor).
	2.	Sensitivity is set too high.
		(Reduce sensitivity.)

SYMPTOM	POSSIBLE CAUSE

Light stays on	1. The sensor is pointed toward
continuously.		a heat source like an air vent,
		dryer vent, or brightly-painted
		heat-reflective surface.(Re-aim
		sensor.)
	2.	Light control is in Manual Mode.
		(Switch to Auto.)
	3.	Light control is in DualBrite®
		mode.
	4.	Sensitivity is set too high. (Re-
		duce sensitivity.)

Light flashes	1.	Sensor is in the Test mode.
on and off.		(While inTEST mode, light only
		stays on for 5 seconds.)
	2.	Heat being reflected from other
		objects may be affecting the
		sensor. (Re-aim sensor.)

Light does not	1.	Nearby large, light-colored
stay on in Man-		objects reflecting light may
ual mode.		trigger the shut-off feature. Do
		not point other lights at the
		sensor.

No Service Parts Available for this Product

See your Canadian Tire retailer for warranty information.

598-1207-01