Samsung VCD9420S31/XSB, VCD9480H3W/XSB manual Troubleshooting, Problem Solution

troubleshooting

PROBLEM	SOLUTION
Motor downs and does	• Check cable, plug and socket.
not start.	• Leave to cool.
Suction force is gradually	• Check for blockage and remove.
decreasing.
Cord does not rewind	• Pull the cord out 2~3m and push down the cord rewind button.
fully.
Vacuum cleaner downs,	• Check hose and replace if required.
does not pick up dirt
Water leakage from the	• Check rubber packing inserted tightly at the upper part.
dust bin.	• Check rubber packing to the lever at the bottom of the dust
	bin.
Excessive water drops	• Some droplets on the inside body are to be expected.
from the inside of the
	Please dry the aqua cyclone fully.
body.
Dirty water comes out	• Check the filter is located properly.
of the top of the main	• If the amount of water becomes excessive, check if water
body	inside dust bin is over the max line and make the water level is
	under the max line.
Water comes out from	• Check the water level of the aqua cyclone.
the back cover.	• Please operate the vacuum cleaner without the aqua cyclone
	until water does not come out from the back cover.
Low or decreasing	• Please check filters. If required clean it as illustrated in the
suction.	instruction. If filters are out of conditions, change them to new
	one.
Body overheating	• Please check filters. If required clean it as illustrated in the
	instruction.
Static electricity	• Please decrease power suction.
discharge
Unpleasant smell during	• Please note that there may be a slight smell during vacuuming
vacuuming	when the cleaner is new (4-5 days).

This Vacuum cleaner is approved the following.

EMC Directive : 2004/108/EEC

Low Voltage Directive : 2006/95/EC

14_ troubleshooting