ELECTRICAL
ELECTRICAL RATING
For models equipped with 120V, 60HZ, 1PH
ELECTRICAL CONNECTION:
The cabinet heating unit has a
For models equipped with 220V, 50HZ, 1PH
ELECTRICAL CONNECTION:
Equipped with a female “IEC 60320 C20” Power inlet which accommodates various power cord configurations for applicable country. The cabinet heating unit has a 2000- watt heating element and requires a
20 AMP RECEPTACLE
IEC 60320 C20 POWER INLET (9 amp)
ifunitisnotgrounded.
LOCATION
Your unit should be located to provide easy access, without restrictions. Factory installed door opens from left to right. Provisions for mounting door to open from right to left are incorporated.
Electrical outlet must be less than (6) ft. from unit operating position. Avoid enclosed or confined locations, which will restrict air circulation.
Electrical Cord Holder Installation
1.) Locate and remove cord holder bracket on top of heater body inside cabinet. See figure 1.
2.) Remove (2) screws from upper right rear of cabinet for later installation See figure 2.
3.) Install bracket with (2) screws and tighten. See figure 3. Completed install see figure 4.
Figure 1 | Figure 2 | Figure 3 | Figure 4 |
OPERATING PROCEDURES
CONTROL PANEL CONFIGURATION
6