Bakers Pride Oven CPH70-MP17 Cleaning Procedures, Ledge Removal, Heater Assembly Removal

Page 8

HEAT AND MOISTURE (SECONDARY CONTROL): Heat and/or moisture can be further controlled by sliding damper, located at top of cabinet, left or right to desired opening.

CLEANING PROCEDURES

LEDGE REMOVAL:

￿Lift up and out of holes in ledge uprights.

HEATER ASSEMBLY REMOVAL:

￿Open door and allow sufficient time for cool down.

￿

￿

Unplug heater cord from receptacle.

Carefully slide heating unit forward. (If in proofing mode and pan has water remaining, avoid water movement to prevent spillage. After unit is totally out and on a stable surface, remove water pan and pour out remaining water.)

When returning heater assembly to its operating position, be sure to line up back end with bottom of louvered air tunnel. (If returning unit to proofing mode, add water only after unit is fully inserted and in operating position.)

8

Image 8
Contents CLASSIC-LINE Proofer Heater Table of Contents Freight Claims Inspection Delivery and Freight ClaimsDelivery Review of Received Goods Prepare for Emergencies Recognize Safety InformationUnderstand Signal Words Follow Safety Instructions Safety and Warning Labels Label LocationsLocation Operating ProceduresElectrical Freshly Prepared Dough To Oper TE AS a Heated Holding CabinetTypical Proofing Preparation Ledge Removal Cleaning ProceduresHeater Assembly Removal Drip Trough Draining and Removal AIR Tunnel RemovalExterior Cleaning Moving CabinetTroubleshooting Problem Probable Cause SolutionGreen Wiring Diagram SJODomestic Warranties and Service International Warranties and Service BevLes