Dell XPSU125327CR manual Replacing the Display Assembly

Replacing the Display Assembly

WARNING: Before working inside your computer, read the safety information that shipped with your computer and follow the steps in "Before Working Inside Your Computer" on page 7. After working inside your computer, follow the instructions in "After Working Inside Your Computer" on page 9.

For more safety best practices, see the Regulatory Compliance home page at dell.com/regulatory_compliance.

Procedure

1Slide the tab on the palm-rest assembly under the display hinges to align the palm-rest assembly and then place it on the display assembly.

2Rotate the display hinges down to insert the tabs on the palm-rest assembly into the slots on the display hinges.

3Replace the screws that secure the display assembly to the palm-rest assembly.

4Connect the power-adapter port cable and display cables to the system board.

NOTE: When connecting the display cables to the system board, match the labels (L and R) on the display cables to the labels on the system board.

5Connect the antenna cables to the wireless card, and then adhere the Mylar and conductive tape over the antenna cables.

Postrequisites

1Replace the heat sink. See "Replacing the Heat Sink" on page 30.

2Replace the battery. See "Replacing the Battery" on page 14.

3Replace the base cover. See "Replacing the Base Cover" on page 12.

Replacing the Display Assembly 39