CFM Corporation 2461, 2462, 2460 manual Operation, Heater Controls and Features Air Controls

Page 17

Dutchwest

Operation

Heater Controls and Features

Air Controls

The Dutchwest Convection Heater has two air controls that regulate the amount of air drawn into the stove. Generally, more air entering the stove allows the ﬁre to burn hotter and faster, while less air decreases heat output while prolonging the overall burn time.

The Primary Air control lever is located at the lower front edge of the left side (looking from the front of the stove). (Fig. 21) The lever operates the two air inlet shutters which are on the front of the stove. Opening the inlet shutters provides air for primary combustion.

Damper

Secondary

Air Inlet

Side Loading

Door

Primary

Air Control

Lever

Front

Loading Door

ST432

Fig. 21 The heater controls.

To open the shutters, turn the lever counterclockwise. The shutters are all the way open when the lever points toward the front at a ”4:30” position. (Fig. 22) To close the shutters, turn the lever clockwise. The shutters are fully closed when the lever points straight down. (Fig. 23)

The secondary air inlet, over the side door, admits air to the catalytic combustor only, for high efﬁciency at high combustor temperatures. Use a gloved hand or the metal tip of the door handle to adjust this inlet. Opening or closing this inlet will not strengthen the ﬁre; generally this inlet should be about one turn open for low ﬁres, and 1¹⁄₂ to 2 turns for medium and high ﬁres.

	Pull Control	Air Inlet
	Pull Control	Shutter
	Lever Forward	Shutter
	Lever Forward
	to Open Air
	Shutters

ST433

Fig. 22 Opening the primary air supply.

ST434

Fig. 23 Closing the primary air supply.

7001135

17

Image 17

Contents Convection Heater Model 2460, 2461 Table of Contents AccessoriesStove Model Number 2460 2461 2462 SpeciﬁcationsMasonry Chimneys InstallationChimney Types Two Types of Connector Guidelines for Installing the Chimney ConnectorSingle-Wall Connector Prefabricated ChimneysAssembling Single-Wall Chimney Connector Double-Wall ConnectorSecuring the Connector To a Prefabricated Chimney Toward Stove Flue Gas DirectionFireplace Installations Above the Fireplace Securing the Connector to a Masonry ChimneyFreestanding Installations Wall Pass-Throughs Fireplace Installations Through the FireplaceModel Canada Fireplace InstallationsFloor Protection Safe Ways To Reduce Clearances Keep the Stove a Safe Distance From Surrounding MaterialsModel Fireplace Installation ClearancesRear exit, rear heat shield installations Designing a Safe InstallationClearance Chart Reference Diagrams Front Clearance to Combustibles Chimney Connector ClearanceStove Clearance Side Rear Corner Model 2460 Small Convection Chimney ConnectorWall Heat Shield Dimensions Attach the Legs and Bottom Heat Shield AssemblyUnpack the Parts Operation Heater Controls and Features Air ControlsLoad Doors Damper Function Burn Only High-Quality FuelSuccessful Wood Burning OpenCatalyst Air Use the Air Control Settings That Work Best for YouPrimary Air Break-in Fires How to Build and Maintain a Wood Fire Loading WoodLighting the Fire Reloading and Reviving the FireSafe Ash Handling Further suggestionsRemove Ashes Frequently Cleaning the Glass MaintenanceAdjust the Door Latch Test And Repair the Door GasketsPrimary Air Control Adjustment Damper AdjustmentRepair Missing Cement in Seams Avoid Damaging the Glass Door PanelInspect Regularly, Clean as Required Cleaning the Chimney SystemMaintenance Schedule Annual Spring CleaningWhen to Suspect a Combustor Problem Yearly Spring CleaningCare of the Catalytic Combustor Assess Your Present Operating ConditionsWatch for Better Results Remove and Inspect the CombustorCatalytic Combustor Draft Management Single Venting Draft TestingBackpufﬁng FuelItem/Description Dutchwest Convection HeaterDutchwest Convection Heater Warranty