Friedrich ZQ10 A10B Features, Control Locations, Control Only Model, Ventilation, Close Vent Open

1.4 FEATURES

•Designed for cooling only.

•Powerful and whisper cooling.

•Slide-in and slide-out chassis for the simple installation and service.

•Side air-intake, side cooled-air discharge.

•Built in adjustable THERMOSTAT.

•Washable one-touch filter.

•Compact size.

•Reliable and efficient rotary compressor equipped.

1.5 CONTROL LOCATIONS

1.5.1 CONTROL ONLY MODEL

• VENTILATION

The ventilation lever must be in the CLOSE position in order to maintain the best cooling conditions. When fresh air is necessary in the room, set the ventilation lever to the OPEN position.

The damper is opened and room air is exhausted.

NOTE

Before using the ventilation feature, make a ventilation kit. First, pull down part to horziontal line with part .

•FOR NORMAL COOLING

1.Turn the Mode switch to the High, Med or Low Cool setting.

2.Set the Temperature control to the desired temperature point (the mid-point is a good starting position). If the room temperature is not satisfactory after a reasonable time, adjust the control to a cooler or warmer setting, as appropriate.

•FOR MAXIMUM COOLING

1.Turn the Mode switch to the High Cool setting.

2.Set the temperature control to the highest temperature point (all the way to the right).

•FOR QUIETER OPERATION

1.Turn the Mode switch to the Low Cool setting.

2.Set the Temperature control as needed.

•Energy Saver Switch

This rocker switch can be depressed to either YES or NO. In the YES position, you will get the most economical operation. Both the fan and the compressor will cycle on and off together, maintaining the selected temperature at a more constant level and reducing the humidity more efficiently. This control will only operate when the unit is in a cooling mode. In the NO position, the fan will run constantly as long as the unit is in the cooling mode.

CLOSE VENT OPEN

Part B

Part A

—4—