Friedrich ZQ10 A10B manual Disassembly Instructions, Mechanical Parts, Front Grille, Cabinet

2. DISASSEMBLY INSTRUCTIONS

— Before disassembling, turn the POWER SWITCH to OFF and disconnect the power cord.

2.1 MECHANICAL PARTS

2.1.1 FRONT GRILLE

1.Open the INLET GRILLE downward and remove the air filter.

2. Remove the screw which fastens the FRONT GRILLE.

3. Pull the FRONT GRILLE from the right side.

4. Remove the FRONT GRILLE.

5. Re-install the component by referring to the above removal procedure. (See figure 1)

Figure 1

Shipping screws

2.1.2 CABINET

1. After disassembling the FRONT GRILLE, remove two screws which fasten the CABINET at both sides.

2. Remove two screws which fasten the CABINET at back.

3. Pull the BASE PAN forward. (See figure 2)

2.1.3 CONTROL BOX

1.Disconnect the unit from the power source.

2.Remove the front grille. (Refer to section 2.1.1)

3.Remove the cabinet. (Refer to section 2.1.2)

4.Remove the screw which fastens the control box cover.

5.Remove the housing which connects motor wire in the control box.

6.Remove the 3 leads from the compressor.

(Refer to section 2.3.1)

7.Discharge the capacitor by placing a 20,000 ohmresistor across the capacitor terminals.

8.Remove the 2 screws which fasten the control box.(See Figure 3)

9.Pull the control box forward completely.

10.Re-install the components by referring to the removal procedure, above. (See Figure 3) (Refer to the circuit diagram found on page 24 in this manual or on the control box.)

Figure 2

Figure 3

— 5—