Dansons Group CCGB 2, CCGB 1 PLANNING-EXHAUST Systems, Pellet Vent Type, Vent Safety Precautions

Page 10

PLANNING—EXHAUST SYSTEMS

PELLET VENT MUST MAINTAIN A MINIMUM 3” CLEARANCE TO ANY COMBUSTIBLE

(INSTALL VENT AT CLEARANCES SPECIFIED BY THE VENT MANUFACTURER).

DO NOT CONNECT THE PELLET VENT TO A VENT SERVING ANY OTHER APPLIANCE OR

STOVE.

DO NOT INSTALL A FLUE DAMPER IN THE EXHAUST VENTING SYSTEM OF THIS UNIT.

PELLET VENT TYPE:

1.Must be an approved 3” or 4” Diameter Type ”PL” vent, vented to the outside (fig. 7) or connect the vent to a factory built type “A” chimney using an adaptor.

2.Exception: A single wall “All Fuel” Stainless Steel chimney liner may be used inside a fireplace or fireplace installations (fig. 8) .

3.Some venting manufactures do make “PL” vent for use with wood pellet fuel only and another type of “PL” vent for corn or bio mass fuels. If in doubt, plan for the future and use the corn or multi-fuel

VENT SAFETY PRECAUTIONS:

A “Clean Out Tee” (4) must be installed at the bottom of all vertical runs. These “Tee’s” are to assist in periodically cleaning the vent. Single or Double clean out tees may be used. The exhaust system must be installed so the entire system can be cleaned without disassembly.

Termination must exhaust above the fresh air inlet elevation, and parallel or above the exhaust output of the multi-fuel appliance.

It is highly recommended that at least 3 feet of vertical pipe (5) be installed to create some natural draft. This is to help prevent the possibility of smoke or odor during the appliance shut down.

Horizontal sections must have a 1/4” rise every 12” of travel after 3’ long.

Pellet vent connections must be sealed gas tight. Use Hi-Temp RTV Silicone, good for over 600° F or Hi-temp Metal foil tape, that meets UL181 standards,. DO NOT use “Duct Tape”.

Seal each vent section by injecting a liberal amount of sealant into the gap and/or wrap with foil tape.

It is strongly recommended that the exhaust system be terminated on the prevailing wind side of the home.

Appliance may not be placed in, or vented through a gas fireplace.

7 8

 

9

6

1

5

 

2

4

 

 

3

Glow Boy Home & Shop Heater

www.glowboystoves.com

10

 

 

10

 

 

 

Image 10
Contents Toll Free Technical Support Glowboy 456 Dear Glow Boy Multi-Fuel / Pellet Stove Owner Friendly ReminderTable of Contents Grounded surge-protection unit is recommended Safety PrecautionsDo not unplug the stove if you suspect a malfunction Safety Testing Fuel Considerations HOW Your Appliance WorksTube Scraper Automatic Safety Features Dimensions SpecificationsHeating Specifications Electrical SpecificationsNecessary for your stove Planning & Installation Check ListPlacement is decided on EssentialPLANNING-EXHAUST Systems Vent Safety PrecautionsPellet Vent Type Determine Venting Size and Distance PLANNING- Exhaust Systems …Step Pellet Vent Termination Figures 7 Vent Termination ClearancesThrough The Wall Kits Include Outside air is Required on ALL Mobile Home InstallationsPLANNING- Outside AIR Foot Package PART# KS5150-1460PLANNING- Protection & Clearances Stove PlacementClearances Straight Installation Floor Protection RequirementsAlcove Installation Clearances Corner InstallationPLANNING- Protection & Clearances . . . CON’T Hand Tools Power ToolsTools Required SuppliesINSTALLATION-FREESTANDING Through the WallMobile Home Installation Ceiling and Roof Must be MaintainedFreestanding Installation . . . CON’T Hearth Stove Existing RelineFreestanding Installation . . . C on ’ T Main Floor Tie-In Claytile Main Floor Class a Tie-InOpening and Closing the Main Door Setting the AIR Inlet DamperOperating Instructions Seating the Burn GrateBasic Overview Fill the Hopper with FuelChoose Mode of Operation Operating in Manual Mode To StartOperating in Thermostat High / LOW Cycle Flashing 3 To Start … con’t After Pushing the Start touch padOperating in Thermostat on / OFF Flashing 1 Trim Pots Fine Tune Adjustments- Factory SettingsAuger Cycle FAN Speed Convection or heatingOperating INSTRUCTION- Lighting Your Appliance Confirm Low 1 Feed Setting and burn, only after Mark the Adjusted AIR Inlet DamperOPERATION- Performance Enhancements Ash Content Fuel SPECIFICATIONS-WOOD PelletsFuel Rate Setting… LengthFuel SPECIFICATIONS-SHELLED Corn Corn QualityDoor & Trim Cleaning MAINTENANCE-ROUTINE CleaningWindow Cleaning Every 2 -3 Days / WeeklyTON, Seasonal or BI-SEASONAL MAINTENANCE- Periodic CleaningExhaust Venting Check and Clean the Hopper Service Contracts Yearly MaintenanceTrouble Shooting Dansons Customer Service atGrate but will not start Cont…Fuel feeds into the burn Burn grate fills with fuelBurn grate. Window Fire burns with a yellowFlame. Fuel builds up Gets real dirty quicklyOptional Accessories Purpose AccessoriesHow to Install Tools NeededExtended Warranty Limited WarrantyParts, Service and Returns Additional Dansons ProductsService & Maintenance LOG Toll Free Technical Support

CCGB 1, CCGB 2 specifications

Dansons Group has made significant strides in the manufacturing and distribution of outdoor cooking products, particularly through their innovative brands like Dansons/BBQ and their specialty line of wood pellets. Among their offerings, CCGB 2 and CCGB 1 have garnered considerable attention for their advanced technology and user-friendly features.

CCGB 2 and CCGB 1 are two versatile outdoor grills designed to enhance the grilling experience for both novice and expert cooks. One of the main features of these grills is their precision temperature control, which allows users to set and maintain specific cooking temperatures with unparalleled accuracy. This is achieved through advanced digital thermostatic controls that monitor and adjust the heat output, ensuring consistent performance and preventing unnecessary flare-ups.

Both models boast robust construction, using high-quality materials that are resistant to corrosion and wear, ensuring longevity and durability even in challenging weather conditions. The spacious cooking area is another standout characteristic, allowing users to prepare large quantities of food simultaneously, making them ideal for gatherings and outdoor events.

The CCGB series is also equipped with a unique wood pellet system that delivers exceptional flavor to grilled foods. The ability to choose from a variety of wood pellet types allows users to customize the smokiness and richness of their dishes, enhancing the overall culinary experience. This feature is especially appealing to barbecue enthusiasts who appreciate the subtle differences that wood smoke imparts to meats and vegetables.

In terms of technology, both CCGB 2 and CCGB 1 incorporate Wi-Fi connectivity, enabling users to monitor and control their grills remotely via a mobile app. This innovative feature provides convenience, allowing users to tend to their cooking without being tethered to their grill. Additionally, the app often includes recipes, temperature presets, and cooking tips, further enhancing the grilling experience.

Safety features are also a priority in the design of CCGB 2 and CCGB 1. These grills have integrated heat shields and protective barriers to minimize the risk of burns and ensure safe operation, even for inexperienced users.

In summary, Dansons Group's CCGB 2 and CCGB 1 stand out in the market for their superior temperature control, versatile wood pellet system, durable construction, and innovative technology. These features not only simplify the grilling process but also elevate the outdoor cooking experience, making them essential tools for anyone looking to master the art of grilling.