Desa UNVENTED (VENT-FREE) PROPANE GAS LOG HEATER Continued, Installing Logs

Page 19
INSTALLING LOGS

INSTALLING

Continued

INSTALLING LOGS

WARNING

WARNING ICON

G 001

Failure to position the parts in accordance with these diagrams or failure to use only parts specifically approved with this heater may result in property damage or personal injury.

Each log is marked with a number. These numbers will help you identify the log when installing. It is very important to install these logs exactly as instructed. Do not modify logs. Only use logs supplied with heater.

1.Slide rear log (#1) into place behind rear burner (see Figure 17).

2.Slide front log (#2) into place behind front burner. Make sure tabs at bottom of log are behind front burner (see Figure 18).

3.Place crossover log (#3) into place (see Figure 19). Be sure to place back of crossover log into notch on left side of rear log. The indentation under front right fork of crossover log must rest on rectangular knob of front log.

4.Place left front branch (#4) and right front branch (#5) (24" and 30" models) or front branch (#4) (18" model) into place (see Figure 20). Make sure notches on bottom rest on grates.

5.Add lava rock around base of heater.

Rear Log (#1)

Front Log (#2)

Tab

 

 

Figure 18 - Installing Front Log

Figure 17 - Installing Rear Log

 

Left Front Branch (#4)

 

(24" & 30" models)

 

Notches

or Front Branch (#4)

Crossover

(18" Model)

Log (#3)

Right Front

 

Branch (#5)

 

Notches

Figure 19 - Installing Crossover Log

Figure 20 - Installing Left Front

Branch and Right Front Branch

19

101309

Image 19
Contents UNVENTED VENT-FREE PROPANE GAS LOG HEATER OWNER’S OPERATION AND INSTALLATION MANUAL18, 24, and 30 Log Sets Thermostat and Manually-ControlledModelsSafety Information continues on next page CONTENTS SAFETY INFORMATIONWARNINGS DANGERINFORMATION SAFETYContinued PRODUCT IDENTIFICATION LOCAL CODES UNPACKING PRODUCT FEATURESVENTILATION AIR FORCOMBUSTION Example 51,200 AIR FOR COMBUSTION AND VENTILATIONContinued DETERMINING AIR FLOW FOR HEATER LOCATIONContinued AIR FORVENTILATION COMBUSTIONINSTALLING ances from floor, ceiling, and adjoining wall ContinuedTO COMBUSTIBLE MATERIALS LOG SIZING REQUIREMENTSContinued INSTALLINGIf Not Using Mantel Safe InstallationNon Combustible If Using MantelSafe Installation ContinuedContinued INSTALLINGraise the mantel to an acceptable height, OR Continued INSTALLING3.You prefer vented operation Continued INSTALLINGINSTALLING HEATER BASE ASSEMBLY Installation Items NeededCONNECTING TO GAS SUPPLY INSTALLINGContinued Vent Pointing Down INSTALLINGContinued Propane Supply Tank External RegulatorContinued INSTALLINGCHECKING GAS CONNECTIONS Figure 15 - Manual Shutoff Valve INSTALLINGContinued Test Pressures Equal To or Less Than 1/2 PSIGINSTALLING LOGS INSTALLINGContinued Thermostat- Controlled Models FOR YOUR SAFETY READ BEFORE LIGHTINGOPERATING HEATER LIGHTING INSTRUCTIONSThermostat MANUAL LIGHTING PROCEDUREOPERATING HEATERLIGHTING INSTRUCTIONS Manually-ControlledModelsFOR YOUR SAFETY READ BEFORE LIGHTING OPERATING HEATERsee Manual Lighting Procedure, below ModelsManually-Controlled MANUAL LIGHTING PROCEDUREPILOT FLAME PATTERN INSPECTING BURNERSFRONT BURNER FLAME PATTERN MAINTENANCE TROUBLESHOOTING CLEANINGContinued TROUBLE- SHOOTINGOne or both burners TROUBLESHOOTING ContinuedContinued TROUBLE- SHOOTINGIf you smell gas Shut off gas supply OF THERMOSTAT OPTIONALPOSITIONING SENSING BULBFor Masonry and Factory-built Metal Fireplace OPTIONAL POSITIONING OF THERMOSTAT SENSING BULBContinued SERVICE SERVICETECHNICAL HINTSParts Under Warranty REPLACEMENT PARTSParts Not Under Warranty BRASS FIREPLACE HOOD - GA6052 ACCESSORIESMANUAL SHUTOFF VALVE - GA5010 BLACK FIREPLACE HOOD - GA6050Manually-Controlled ILLUSTRATEDPARTS BREAKDOWNVL24P/CF24P PARTS LISTPART NUMBER FOR VL18P/CF18PThermostat ILLUSTRATEDPARTS BREAKDOWNVL24PT/CF24PT PARTS LISTPART NUMBER FOR VL18PT/CF18PT101309 101309 LIMITED WARRANTY VENT-FREEPROPANE GAS LOG HEATERS WARRANTY INFORMATIONKEEP THIS WARRANTY