Desa UNVENTED (VENT-FREE) PROPANE GAS LOG HEATER Air For, Ventilation, Combustion

Page 5
AIR FOR

AIR FOR

WARNING

COMBUSTION

This heater shall not be installed in a confined space unless

AND

provisions are provided for adequate combustion and ventilation

VENTILATION

air. Read the following instructions to insure proper fresh air for

this and other fuel-burning appliances in your home.

 

 

 

Today’s homes are built more energy efficient than ever. New materials, increased

 

insulation, and new construction methods help reduce heat loss in homes. Home

 

owners weather strip and caulk around windows and doors to keep the cold air out

 

and the warm air in. During heating months, home owners want their homes as

 

airtight as possible.

 

While it is good to make your home energy efficient, your home needs to breathe.

 

Fresh air must enter your home. All fuel-burning appliances need fresh air for

 

proper combustion and ventilation.

 

Exhaust fans, fireplaces, clothes dryers, and fuel burning appliances draw air from

 

the house to operate. You must provide adequate fresh air for these appliances.

 

This will insure proper venting of vented fuel-burning appliances.

 

PROVIDING ADEQUATE VENTILATION

 

The following is exerpts from National Fuel Gas Code. NFPA 54/ANSI Z223.1,

 

Section 5.3, Air for Combustion and Ventilation.

 

All spaces in homes fall into one of the three following ventilation classifications:

 

1. Unusually Tight Contruction; 2. Unconfined Space; 3. Confined Space.

 

The information on pages 5 through 7 will help you classify your space and provide

 

adequate ventilation.

 

Unusually Tight Construction

 

The air that leaks around doors and windows may provide enough fresh air for

 

combustion and ventilation. However, in buildings of unusually tight construction,

 

you must provide additional fresh air.

Unusually tight construction is defined as construction where:

a.walls and ceilings exposed to the outside atmosphere have a continu- ous water vapor retarder with a rating of one perm or less with open- ings gasketed or sealed and

b.weather stripping has been added on openable windows and doors and

c.caulking or sealants are applied to areas such as joints around window and door frames, between sole plates and floors, between wall-ceiling joints, between wall panels, at penetrations for plumbing, electrical, and gas lines, and at other openings.

If your home meets all of the three criteria above, you must provide addi- tional fresh air. See Ventilation Air From Outdoors, page 7.

If your home does not meet all of the three criteria above, proceed to page 6.

Unconfined Space

The National Fuel Gas Code, ANSIZ223.1, 1992, Section 5.3 defines uncon- fined space as having a minimum air volume of 50 cubic feet (127 cubic cm) for each 1000 Btu/Hr input rating of all appliances in the space (cubic feet equals length x width x height of space). Include adjoining rooms only if there are doorless passageways or ventilation grills between the rooms.

Confined Space

The National Fuel Gas Code, ANSIZ223.1, 1992, Section 5.3 defines confined

 

space as having an air volume of less than 50 cubic feet (127 cubic cm) for each

 

1000 Btu/Hr input rating of all appliances in the space (cubic feet equals length

 

x width x height of space). Include adjoining rooms only if there are doorless

 

passageways or ventilation grills between the rooms.

Continued

5

101309

Image 5
Contents 18, 24, and 30 Log Sets OWNER’S OPERATION AND INSTALLATION MANUALThermostat and Manually-ControlledModels UNVENTED VENT-FREE PROPANE GAS LOG HEATERWARNINGS CONTENTS SAFETY INFORMATIONDANGER Safety Information continues on next pageContinued SAFETYINFORMATION PRODUCT IDENTIFICATION LOCAL CODES UNPACKING PRODUCT FEATURESCOMBUSTION AIR FORVENTILATION Continued AIR FOR COMBUSTION AND VENTILATIONDETERMINING AIR FLOW FOR HEATER LOCATION Example 51,200VENTILATION AIR FORCOMBUSTION ContinuedINSTALLING TO COMBUSTIBLE MATERIALS ContinuedLOG SIZING REQUIREMENTS ances from floor, ceiling, and adjoining wallIf Not Using Mantel INSTALLINGSafe Installation ContinuedSafe Installation If Using MantelContinued Non Combustibleraise the mantel to an acceptable height, OR INSTALLINGContinued 3.You prefer vented operation INSTALLINGContinued INSTALLING HEATER BASE ASSEMBLY INSTALLINGInstallation Items Needed ContinuedContinued INSTALLINGCONNECTING TO GAS SUPPLY Continued INSTALLINGPropane Supply Tank External Regulator Vent Pointing DownCHECKING GAS CONNECTIONS INSTALLINGContinued Continued INSTALLINGTest Pressures Equal To or Less Than 1/2 PSIG Figure 15 - Manual Shutoff ValveContinued INSTALLINGINSTALLING LOGS OPERATING HEATER FOR YOUR SAFETY READ BEFORE LIGHTINGLIGHTING INSTRUCTIONS Thermostat- Controlled ModelsOPERATING MANUAL LIGHTING PROCEDUREHEATER ThermostatFOR YOUR SAFETY READ BEFORE LIGHTING Manually-ControlledModelsOPERATING HEATER LIGHTING INSTRUCTIONSManually-Controlled ModelsMANUAL LIGHTING PROCEDURE see Manual Lighting Procedure, belowFRONT BURNER FLAME PATTERN INSPECTING BURNERSPILOT FLAME PATTERN SHOOTING TROUBLECLEANING MAINTENANCEContinued TROUBLE- SHOOTINGSHOOTING TROUBLEContinued One or both burnersIf you smell gas Shut off gas supply TROUBLE- SHOOTINGContinued POSITIONING OPTIONALSENSING BULB OF THERMOSTATContinued OPTIONAL POSITIONING OF THERMOSTAT SENSING BULBFor Masonry and Factory-built Metal Fireplace TECHNICAL SERVICEHINTS SERVICEParts Not Under Warranty REPLACEMENT PARTSParts Under Warranty MANUAL SHUTOFF VALVE - GA5010 ACCESSORIESBLACK FIREPLACE HOOD - GA6050 BRASS FIREPLACE HOOD - GA6052PARTS ILLUSTRATEDBREAKDOWN Manually-ControlledPART NUMBER FOR PARTS LISTVL18P/CF18P VL24P/CF24PPARTS ILLUSTRATEDBREAKDOWN ThermostatPART NUMBER FOR PARTS LISTVL18PT/CF18PT VL24PT/CF24PT101309 101309 KEEP THIS WARRANTY WARRANTY INFORMATIONLIMITED WARRANTY VENT-FREEPROPANE GAS LOG HEATERS