Desa VMH3000TPA Operating Heater, For Your Safety Read Before Lighting, Lighting Instructions

Page 14

14

OPERATING HEATER

For Your Safety Read Before Lighting Lighting Instructions

OPERATING HEATER

FOR YOUR SAFETY READ

BEFORE LIGHTING

WARNING: If you do not follow these instructions exactly, a fire or explosion may result causing prop- erty damage, personal injury or loss of life.

A.This appliance has a pilot which must be lighted by hand. When lighting the pilot, follow these instructions exactly.

B.BEFORE LIGHTING smell all around the appliance area for gas. Be sure to smell next to the floor because some gas is heavier than air and will settle on the floor.

WHAT TO DO IF YOU SMELL GAS

•Do not try to light any appliance.

•Do not touch any electric switch; do not use any phone in your building.

•Immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier’s instructions.

•If you cannot reach your gas supplier, call the fire de- partment.

C.Use only your hand to push in or turn the gas control knob. Never use tools. If the knob will not push in or turn by hand, don’t try to repair it, call a qualified service techni- cian or gas supplier. Force or attempted repair may result in a fire or explosion.

D.Do not use this appliance if any part has been under water. Immediately call a qualified service technician to inspect the appliance and to replace any part of the control system and any gas control which has been under water.

Note: If pilot does not stay lit, refer to Troubleshooting, pages 17 through 19. Also contact a qualified service per- son or gas supplier for repairs. Until repairs are made, light pilot with match. To light pilot with match, see Manual Lighting Procedure, page 15.

7.Keep control knob pressed in for 30 seconds after lighting pilot. After 30 seconds, release control knob.

•If control knob does not pop up when released, contact a qualified service person or gas supplier for repairs.

Note: If pilot goes out, repeat steps 3 through 7. This heater has a safety interlock system. Wait one (1) minute before lighting pilot again.

8.Turn control knob counterclockwise C-clockwiseto desired heating level. The main burner should light. Set control knob to any heat level between HI and LO.

CAUTION: Do not try to adjust heating levels by using the equipment shutoff valve.

Ignitor Button

 

Control Knob

 

 

O

 

 

L

 

ILP

 

 

TO

 

 

OFF

I H

 

 

IGNITOR

 

 

Figure 23 - Control Knob In The OFF Position

Ignitor Electrode

Thermocouple

Pilot Burner

LIGHTING INSTRUCTIONS

1.STOP! Read the safety information above.

2.Make sure equipment shutoff valve is fully open.

3. Turn control knob clockwise Clockwise to the OFF position.

4.Wait five (5) minutes to clear out any gas. Then smell for gas, including near the floor. If you smell gas, STOP! Fol- low “B” in the safety information above. If you don’t smell gas, go to the next step.

5. Turn control knob counterclockwise C-clockwiseto the PILOT position. Press in control knob for five (5) seconds (see Fig- ure 23).

Note: You may be running this heater for the first time after hooking up to gas supply. If so, the control knob may need to be pressed in for 30 seconds. This will allow air to bleed from the gas system.

6.With control knob pressed in, push down and release ignitor button. This will light pilot. The pilot is attached to the front of burner. If needed, keep pressing ignitor button until pilot lights.

Figure 24 - Pilot (Natural Gas)

Thermocouple

Ignitor Electrode

Pilot Burner

Figure 25 - Pilot (Propane/LP Gas)

For..com

109889

Page 13 Page 15
Image 14
Page 13 Page 15
Contents What to do if YOU Smell GAS 15,000 to 30,000 Btu/Hr With ThermostatTable of Contents Safety InformationUnpacking Local CodesProduct Identification Product Features Assembling HeaterAttaching Brass Front Trim to Front Panel AssemblyAIR for Combustion and Ventilation Assembling and Attaching Brass TrimUnusually Tight Construction Providing Adequate VentilationDetermining FRESH-AIR Flow for Heater Location Confined and Unconfined SpaceVentilation Air From Outdoors Ventilation AIRVentilation Air From Inside Building Check GAS Type InstallationInstallation Items Locating HeaterMounting Heater to Wall Installation OptionsThermostat Sensing Bulb Placing Heater On Mounting Bracket Installing Bottom Mounting ScrewsMounting Heater on Optional Hearth Base See Instructions Included With Mantel Kit Assembling Mantel Securing Hearth Base to FloorMounting Heater to Optional Hearth Base Connecting to GAS Supply Internally-tinned copper tubing may be used in cerChecking GAS Connections Pressure Testing Gas Supply Piping SystemPressure Testing Heater Gas Connections Lighting Instructions For Your Safety Read Before LightingOperating Heater Inspecting Burner Cabinet Cleaning MaintenanceCleaning Burner Injector Holder and Pilot AIR Inlet Hole Air PassagewaysTroubleshooting Observed Problem Possible Cause RemedyMaintenance, Observed Problem Possible Cause Service Hints SpecificationsReplacement Parts Technical ServiceAccessories Illustrated Parts Breakdown RFN30TA RFP30TA VMH3000TNA VMH3000TPAParts List NJF-8CParts Centrals FBDOwners Registration Form Postage Required 109889 Not a UPC

VMH3000TPA specifications

The Desa VMH3000TPA is a state-of-the-art heating appliance designed to deliver efficient warmth while ensuring user comfort and convenience. This model is widely recognized for its innovative technologies, smart design, and eco-friendly features, making it an ideal choice for residential spaces.

One of the standout features of the VMH3000TPA is its powerful heating capacity. With a robust output of 30,000 BTUs, it is engineered to heat large areas effectively, making it perfect for living rooms, open-plan spaces, or even workshops. Users can expect a consistent and reliable warmth throughout the chilly seasons, enhancing home comfort while reducing reliance on traditional heating systems.

The VMH3000TPA incorporates advanced heating technology, including a variable speed blower that allows for more efficient heat distribution. This feature ensures that warm air circulates evenly throughout the room, eliminating cold spots and creating a cozy atmosphere. Additionally, the unit has a programmable thermostat, allowing users to set and maintain their desired temperature easily.

For safety, the VMH3000TPA is equipped with multiple safety features, including an automatic shut-off function that activates if the unit overheats or tips over. This ensures peace of mind, especially in households with children or pets. Its durable construction includes a fireproof casing and a heat-resistant glass front, designed to withstand high temperatures while maintaining an attractive appearance.

The Desa VMH3000TPA is also designed with energy efficiency in mind. It operates on propane or natural gas, providing a cleaner-burning alternative to traditional heating methods. This model complies with environmental regulations, helping to reduce carbon emissions while lowering energy costs.

Another remarkable aspect is its user-friendly interface, which includes remote control functionality. Users can conveniently adjust settings from a distance, enhancing usability and comfort. This modern appliance is not just a heating solution; it is a blend of technology and design, ensuring that it complements any home décor while providing effective heating solutions.

In summary, the Desa VMH3000TPA stands out in the heating appliance market for its powerful performance, intelligent features, energy efficiency, and safety standards, making it a worthy investment for modern households seeking comfort and reliability during the colder months.
Top Page Image Contents