Desa RFN30TA Attaching Brass Front Trim to Front Panel, Assembling and Attaching Brass Trim

VENT-FREE NATURAL GAS HEATER

ASSEMBLY

Continued

5.	Slide other end of adjusting plate/shim
	in slot on mitered edge of side brass
	trim (see Figure 5).
6.	While firmly holding edges of brass

Log

Front Panel	Sheet Metal
	Screw

Truss-

Head

Screw

Nut

Deflector

Heater

Cabinet

Hood

Log

Retaining

Brackets

Burner Shield

Screw

	trim together, tighten both set screws
	on the adjusting plate with slotted
	screwdriver.
7.	Repeat steps 1 through 6 for other side.
8.	Place the assembled trim on front of
	heater cabinet. Attach on top and sides
	with four brass screws included in hard-
	ware package (see Figure 6).
9.	Reattach front panel to heater if you are
	going to mount the heater to the base.
	Do not reattach front panel at this time
	if you are going to mount heater to wall.

		Set Screws	Top
Side Brass
	Adjusting		Brass
Trim			Trim
	Plate

Brass Front Trim Screen

Screw

	Shim	Slot
Slot	Mitered Edge

Figure 3 - Assembling Heater

WARNING: Always have burner shield and screen in place before operating heater. This pre- vents excessive temperatures on heater surfaces.

Failure to position the parts in accordance with these diagrams or failure to use only parts spe- cifically approved with this heater may result in property damage or personal injury.

Attaching Brass Front Trim to Front Panel

1.Locate brass front trim in brass trim package.

2.Slide the head of two truss-head screws from hardware packet into each end of brass front trim (see Figure 4).

3.Line up screws with holes in front panel (see Figure 3). Insert screws in holes. Attach nuts from inside of front panel. Tighten with wrench.

Front

BrassPanel

Front

Trim

Truss-Head	Nut
Screw

Figure 4 - Attaching Brass Front Trim to Front Panel

Assembling and Attaching Brass Trim

1.Remove packaging from remaining three pieces of brass trim.

2.Locate four brass screws, two adjust- ing plates with set screws, and two shims in the hardware packet.

3.Align shim under adjusting plate as shown in Figure 5.

4.Slide one end of adjusting plate/shim in slot on mitered edge of top brass trim (see Figure 5).

Figure 5 - Assembling Brass Trim

Screws

Assembled

Brass Trim

Figure 6 - Attaching Brass Trim to Heater

For more information, visit www.desatech.com 4 107099