Desa RCLP50VA owner manual Storage, To Start Heater, To Stop Heater, To Restart Heater

Page 6

PROPANE CONSTRUCTION HEATER

OPERATION

WARNING: Review and un- derstand the warnings in the Safety Information section, page

2.They are needed to safely op- erate this heater. Follow all local codes when using this heater.

TO START HEATER

1.Follow all installation, ventilation, and safety information.

2.Locate heater on stable and level sur- face. Make sure strong drafts do not blow into front or rear of heater.

3.Plug power cord of heater into a three- prong, grounded extension cord. Exten- sion cord must be at least 2 m (6 ft). Extension cord must be UL/CSA listed.

Extension Cord Wire Size Requirements

Up to 15 m (50 ft), use 18 AWG rated cord.

16 to 30 m (51 to 100 ft) long, use 16 AWG rated cord.

31 to 60 m (101 to 200 ft) long, use 14 AWG rated cord.

4.Plug extension cord into a 120 volt/60 hertz, 3-hole, grounded outlet. Motor will start. Fan will turn, forcing air out front of heater.

5.Open propane supply valve on propane tank(s) slowly. Note: If not opened slowly, excess-flow check valve on pro- pane tank may stop gas flow. If this happens, close propane supply valve and open again slowly.

WARNING: Be sure motor and fan are running before pushing in automatic control valve but- ton. Flames could flash outside heater if motor and fan are not running.

6.Turn control knob to the low position and push in (see Figure 8). Hold knob in and push piezo ignitor button. You may need to push piezo ignitor button 3-8 times until the main burner lights. When main burner lights, keep auto- matic control valve knob pushed in. Release button after 30 seconds.

Note: If main burner fails to light, hose may have air in it. If so, keep control knob pressed and wait 20 seconds. Re- lease control knob and wait 20 seconds for unburned fuel to exit heater. Repeat step 6.

7.If main burner goes out, repeat step 6.

8.When main burner remains lit, rotate control knob to the desired heat level.

OFF

START/

LOW

MED

HIGH

Figure 8 - Control Knob Positions

Piezo Ignitor

Button

Automatic Control

Valve Knob

Figure 9 - Automatic Control Valve Button and Piezo Ignitor Button

TO STOP HEATER

1.Tightly close propane supply valve on propane tank(s). Allow heater to burn remaining fuel in hose.

2.Shut off main burner valve. Do this by turning control knob to the OFF posi- tion until it stops.

TO RESTART HEATER

1.Wait five minutes after stopping heater.

2.Repeat steps under To Start Heater.

STORAGE

CAUTION: Disconnect heater from propane supply tank(s).

1.Store propane tank(s) in safe manner. See Chapter 5 of Standard for Storage and Handling of Liquefied Petroleum Gases, ANSI/NFPA 58. Follow all lo- cal codes. Always store propane tanks outdoors.

2.Place plastic cover caps over brass fittings on inlet connector and hose/ regulator assembly.

3.Store in dry, clean, and safe place. Do not store hose/regulator assembly in- side heater combustion chamber.

4.When taking heater out of storage, al- ways check inside of heater. Insects and small animals may place foreign ob- jects in heater. Remove motor and other internal parts if needed to remove for- eign objects (see Service Procedures, page 8).

6

105339

Page 5 Page 7
Image 6
Page 5 Page 7
Contents Canadian Propane Construction Heater VariableSafety Information Propane Construction HeaterProduct Identification UnpackingPropane Supply Assembly Theory OperationInstallation VentilationTo Start Heater Extension Cord Wire Size RequirementsStorage To Stop HeaterObserved Fault Possible Cause Remedy MaintenanceTroubleshooting Do not block the flow of com- bustion or ventilation airService Procedures Electrical SystemMotor FAN IgnitorIllustrated Parts Breakdown RCLP50VAParts List KEY Part Description QTYAccessories SpecificationsReplacement Parts Parts Under Warranty105339 Warranty Service Repair ServiceManuel D’UTILISATION Informations Concernant LA Sécurité AvertissementsIdentification DU Produit DéballageAlimentation EN Propane Nombre deAlimentation EN Combustible Principe DE FonctionnementAssemblage AIR ForcéPositionnement du détendeur Arrêt DE L’APPAREIL FonctionnementMise EN Marche Remise EN MarcheRemisage EntretienDépannage Problème Cause Possible RemèdeProcédures ’ENTRETIEN Circuit ÉlectriqueMoteur Ventilateur AllumeurPièces Détachées AccessoiresCaractéristiques Pièces Sous GarantieVUE Éclatée DES Pièces Liste DES Pièces Pièce DE RÉF Description QTÉService DE Réparations Conserver Cette Garantie Garantie LimitéeRéparations Sous Garantie

RCLP50VA specifications

Desa RCLP50VA is an innovative and efficient heating solution designed to meet the modern demands of both residential and commercial environments. This model stands out due to its advanced technology and user-friendly features, making it a preferred choice for heating needs.

One of the most prominent features of the Desa RCLP50VA is its high-efficiency performance. It utilizes state-of-the-art combustion technology to deliver robust heating output while minimizing energy consumption. This efficiency not only reduces utility bills but also contributes to a more sustainable energy footprint, aligning with the growing demand for environmentally responsible appliances.

The unit is powered by liquid propane, which ensures consistent and reliable heat during cold weather conditions. Its versatile design allows it to be installed in various settings, providing users with flexibility in heating larger spaces. The heating capacity of the Desa RCLP50VA is substantial, making it suitable for workshops, garages, and even larger residential areas.

Another key characteristic of the RCLP50VA is its safety features. It includes an automatic shut-off function that activates in case of overheating or other malfunctions. This feature provides peace of mind to users, ensuring safe operation even in busy environments. Additionally, it is equipped with a built-in oxygen depletion sensor, which monitors air quality and halts operation if harmful levels of carbon monoxide are detected.

The construction of the Desa RCLP50VA emphasizes durability and longevity. It boasts a rugged exterior designed to withstand the rigors of both industrial and residential use. The materials employed are resistant to corrosion, ensuring the unit maintains its performance over time.

The user interface of the RCLP50VA is straightforward, with an easy-to-read control panel that allows users to adjust temperature settings and monitor operational status. This intuitive design eliminates confusion, making it accessible for all users, regardless of their technical expertise.

In conclusion, the Desa RCLP50VA is a top-tier heating solution characterized by its efficiency, safety features, and user-friendly design. Its advanced technologies and robust construction make it an ideal choice for anyone looking to invest in a reliable and effective heating system that meets the demands of today’s energy-conscious consumers.
Top Page Image Contents