Automatic charging
Recharging |
When the battery indicator blinks during cleaning, POWERbot will return to the charger to charge itself automatically.
You may command POWERbot to recharge at the charger while it is in cleaning process.
Low battery (Lo)
Manually charge POWERbot by placing it on the charger.
Steps to take if recharging is not being executed
Check the installation status of the charger when:
ffcharger is located in a place where POWERbot cannot easily access
ffdistance of the charger and POWERbot is over 5 m apart
––It may take a long time for POWERbot to return to the charger for recharging
Manually charge POWERbot when:
ffcharger is located in a corner ffbattery is fully exhausted
ffPOWERbot is stuck by obstacles (furniture etc.)
ffPOWERbot can't climb threshold near charger (Height of the threshold that POWERbot can climb: about 1.5 cm and below)
ffwhen battery indicator blinks and "Lo" is displayed
ffwhen POWERbot is set on Spot clean or Manual clean mode