CAUTION Before use
ffInsert the dustbin before using POWERbot.
ffOpen room doors before cleaning in order to have all rooms cleaned and install a Virtual guard in front of entryway, balconies, bathrooms, or other areas where POWERbot may fall.
ffBe careful with the followings for proper automatic recharging.
––Always turn on the power of the charger.
––Install the charger where POWERbot can easily find.
––Do not leave any object in front of the charger.
ffWhen installing the charger, do not leave the cord carelessly on the floor since POWERbot may get tangled by it.
ffDo not use POWERbot on black colored floors.
––The POWERbot may not be able to operate normally.
ffDo not pick up POWERbot by the dustbin holder.
ffDo not place any objects within 0.5 m to both sides and 1 m to the front of the charger.
ffMake sure the charger's charging contact is not damaged or have any foreign matters on it.
ffDo not install the charger in an area with a dark floor.
––If the floor around the charger is dark, recharging is hindered.
ffMove any obstacles that may disturb POWERbot's movement (such as children's indoor swing or slides) before cleaning.
CAUTION In use
ffUsing POWERbot on thick carpet may damage both POWERbot and the carpet.
––The POWERbot cannot pass over carpet that is thicker than 1 cm.
ffDo not use POWERbot on tables or other high surfaces.
–– There is a risk of damage if it falls.
ffThe POWERbot may bump into chair, desk legs therefore move them away for faster and efficient cleaning.
ffWhen POWERbot is operating, do not lift it up or carry it to another area.
ffDo not hold by driving wheels of POWERbot when carrying it to another area.
ffDo not put any objects on top of POWERbot since it may cause malfunction.
ffRemove any large papers or plastic bags immediately when using POWERbot since they may block the intake.
ffDo not aim the red pointer directly at people or animals.
CAUTION Cleaning and maintenance
ffPrevent any damage to POWERbot by complying the followings.
––Do not clean POWERbot by spraying water directly onto it or use benzene, thinner, acetone or alcohol to clean it.
ffDo not disassemble or repair POWERbot. This should only be done by a certified repairman.
ffAlways keep the obstacle sensor and cliff sensor clean.