assembling the cleaner
ATTACH HANDLE TO VACUUM
1.Stand the vacuum upright and slide the base of the handle firmly into the grooves at the top of the vacuum body.
2.Check to be sure the handle is fitted to the vacuum body. If there is a gap, continue to push firmly until the handle is flush.
3.Insert the 25mm screws provided from the bag with an accessory holder into the existing holes each side.
Tighten securely with a screwdriver.
Accessory Holder
25mm screws 
(2EA) to assemble
Handle
16mm screw (1EA) to
assemble Accessory Holder
ATTACH VACUUM HOSE AND TOOLS
1.Align tabs on end of hose with slots in edge of hose attachment hole on back of vacuum. Push hose end in and turn clockwise to lock into place.
2.Slide the end of the hose wand onto the hose wand base.
Note : The vacuum will not operate properly unless the hose wand is firmly attached.
3.Snap the hose into the hose clip on the back of the vacuum handle.
4.Attach the accessory holder by lining up the tab on the base with the corresponding notch on the back of the vacuum and insert a 16mm screw provided from the bag with an accessory holder into the existing hole. Tighten securely with a screwdriver.
5.Slide the extension wand and the crevice tool together into the accessory holder right side.
6.Attach the combination tool into the accessory holder left side as shown.
7.Store Petz Turbo Brush (or Mini Turbo Brush) on the front of the handle by lining up the Petz Turbo Brush (or Mini Turbo Brush) base with the base of the holder then push back to snap into place.
1
4
7 2
1
✽ Option
3
6
5
2
6_ assembling the cleaner