Assembling the cleaner
ATTAcH HANdLE TO VAcUUM
1.Stand the vacuum upright and slide the base of the handle fi rmly into the grooves at the top of the vacuum body.
2.Check to be sure the handle is fi tted to the vacuum body. If there is a gap, continue to push fi rmly until the handle is fl ush.
3. Insert the screw provided from the screw packet into the existing hole.
Tighten securely with a screwdriver.
ATTAcH dUST BIN TO VAcUUM
Fit the groove located on the lower front side of the Dust Bin to the hook located on the vacuum body and attach the hook located on the Dust Bin Handle to the vacuum body as shown.
ATTAcH VAcUUM HOSE ANd TOOLS
01 ASSEMBLING THE cLEANER
1.Attach the Twist Snap Hose by lining up the taps on the base with the corresponding notches on the back of the vacuum as shown.
2.Turn the Twist Snap Hose clockwise to lock the hose into place.
3.Grasping the Hose Wand, slide the end of the it onto the Hose Wand Base. Snap the Hose into the Hose Clip.
Note: The vacuum will not operate effectively unless the Hose Wand is fi rmly attached.
4.Attach the Lower Cord Wrap by lining up the tab on the base with the corresponding notch on the back of the vacuum and turn it clockwise as shown.
5.Attach the Extension Wand and the Crevice Tool together into the holder on the right side of the body as shown.
6.Attach the Combination Tool into the holder on the left side of the body as shown.
7.Attach the Bracket Brush on the front of the handle and clip the Mini Turbo Brush into the Bracket Brush as shown.
* Select Models Only
assembling the cleaner _