Troubleshooting
Check this list of possible problems and solutions before bringing your vacuum to a service center.
PROBLEM
POSSIBLE SOLUTION
Vacuum cleaner won’t run
•Power cord not plugged in
•Blown fuse/tripped breaker in home
•Check electrical plug
•Check/ Replace fuse or reset breaker
Vacuum cleaner and tools won’t pick up dirt
•Incorrect Height Adjustment
•Hose not attached to suction opening
•Twist Snap Hose not securely attached
•Crack or hole in Hose
•Broken or worn Drive Belt
•Rotating Floor Brush bristles worn
•Rotating Floor Brush jammed
•Clog in vacuum
•Dust Bin full
•Dust Bin not installed properly
•Filters are dirty
•Mini Turbo Brush is clogged or debris is wrapped around the brush roll
•Adjust Powerfoot to correct height setting
•Firmly push Hose Wand onto the suction opening
•Make sure Twist Snap Hose is snapped into locked position.
•Check Hose and replace if needed
•Replace Drive Belt, see pg.12
•Replace Brush
•Remove brush and clean debris from brush ends
•Clear clog, see
•Empty Dust Bin
•Position correctly and lock in place
•Check
•Maintaining Mini Turbo Brush, see pg.13
Visible dirt escaping from cleaner
•Dust Bin full
•Filters missing or installed incorrectly
•Dust Bin installed incorrectly
•Empty Dust Bin
•Check
•Pull out and
This Vacuum cleaner is approved the following. Electromagnetic Compatibility Directive : 2004/108/EEC Low Voltage Directive : 2006/95/EC
14_ troubleshooting