INSTALLATION STACKING
In case of purchasing the additional stacking kit, contact our Samsung service center or local distributers. [Part no.
1. Carefully lay the dryer on its side. Use the packing material so you don’t scratch the finish on the dryer.
2. Install rubber pads to dryer base.
• Locate the 4 rubber pads in the parts package. Insert the rubber pads into the holes at the bottom of the levelling legs.
•Purchase the
3.Set the dryer upright.
The stacking kit can only be installed for Samsung family products.
CAUTION |
| |
4. Install bracket to dryer. | ||
• Remove washer top cap screw from the rear left. | ||
| ||
Align left bracket holes with top cap screw hole on |
| |
rear left of the unit and replace screw. |
| |
Leave screw loose so dryer hole alignment will be |
| |
easier. |
|
• Repeat the above step with the right side.
01 INSTALLING YOUR DRYER
5.Install dryer and bracket on washer
•Lift the dryer on top of the washer. Protect the washer
WARNING | control panel with cardboard or other protection. Be |
| sure to lift the dryer high enough to clear the washer |
| control panel. |
Personal Injury. More than two people are recommended to lift the dryer into position because of its weight and size. Failure to do so could result in injury.
Screw |
•Align the holes in the bracket with the holes in the back of the dryer.Using a Phillips screwdriver, attach the M4x12 tapping screws.
•Tighten the washer bracket screws ; then tighten all stacking kit screws.
6. Finalise the installation |
| |
• | Refer to the washer Installation Instructions to | Dryer |
WARNING | complete the washer installation. |
|
• Refer to the dryer Installation Instructions to complete |
| |
| the dryer installation. |
|
• | Carefully slide or walk the stacked washer and dryer | Washer |
| into place. Use felt pads or other sliding device to |
|
| assist moving and to protect flooring. |
|
Do not push on the dryer once installed to top of the washer. Pushing on the dryer may result in pinched fingers.
installing your dryer _15