CB 1200 Pellet Stove Fire Safety | Quadra-Fire CB1200M-MBK specification

CB 1200 Pellet Stove

F. Fire Safety

To provide reasonable fire safety, the following should be given serious consideration:

•Install at least one smoke detector on each floor of your home.

•Locate smoke detector away from the heating appliance and close to the sleeping areas.

•Follow the smoke detector manufacturer’s placement and installation instructions and maintain regularly.

•Conveniently locate a Class A fire extinguisher to contend with small fires.

•In the event of a hopper fire:

•Evacute the house immediately.

•Notify fire department.

G. Tools And Supplies Needed

Tools and building supplies normally required for installation, unless installing into an existing masonry fireplace:

Reciprocating Saw	Safety Glasses
Channel Locks	Framing Square
Hammer	Electric Drill & Bits (1/4”)
Phillips Screwdriver	1/4” Self-Tapping Screws
Tape Meausre	May also need:
Plumb Line	May also need:
Level	Vent Support Straps
Framing Material	Venting Paint
Hi-temp Caulking Material
Gloves

WARNING

Inspect appliance and components for damage. Damaged parts may impair safe operation.

•Do NOT install damaged components.

•Do NOT install incomplete components.

•Do NOT install substitute components.

Report damaged parts to dealer.

WARNING

Fire Risk.

Hearth & Home Technologies disclaims any responsibility for, and the warranty will be voided by, the following actions:

•Installation and use of any damaged appliance.

•Modification of the appliance.

•Installation other than as instructed by Hearth & Home Technologies.

•Installation and/or use of any component part not approved by Hearth & Home Technologies.

•Operating appliance without fully assembling all components.

•Operating appliance without legs attached (if supplied with unit).

•Do NOT Overfire

Or any such action that may cause a fire hazard.

H. Inspect Appliance & Components and Pre-Burn Check List

1.		Place the appliance in a location near the
		final installation area and follow the proce-
		dures below:
2.		Open the appliance and remove all the parts
		and articles packed inside the Component
		Pack. Inspect all the parts and glass for ship-
		ping damage. Contact your dealer if any irregu-
		larities are noticed.
3.		All safety warnings have been read and fol-
		lowed.
4.		This Owner’s Manual has been read.
5.		Floor protection requirements have been met.
6.		Venting is properly installed.
7.		The proper clearances from the appliance and
		chimney to combustible materials have been
		met.
8.		The masonry chimney is inspected by a profes-
		sional and is clean, or the factory built metal
		chimney is installed according to the manufac-
		turer’s instructions and clearances.
9.		The chimney meets the required minimum
		height.
10.		All labels have been removed from the glass
		door.
11.		Plated surfaces have been wiped clean, if
		applicable.
12.		Thermostat or remote has been installed.
13.		A power outlet is available nearby.

December 16, 2011

7014-179D

Page 7

CB1200M-MBK specifications

The Quadra-Fire CB1200M-MBK is a remarkable addition to the lineup of high-efficiency wood stoves, designed to provide exceptional heating performance while maintaining a user-friendly interface and aesthetic appeal. Known for its sleek design and modern technology, the CB1200M-MBK stands out as a powerful solution for both environmentally conscious homeowners and those in search of reliable warmth during cold months.

One of the main features of the CB1200M-MBK is its high efficiency rating, often exceeding 75%. This impressive figure is attributed to its innovative combustion technology, which maximizes wood-burning efficiency by promoting complete combustion. This means more heat is generated from less wood, translating to reduced emissions and less frequent refueling. This efficient design not only benefits the environment but also provides a cost-effective heating solution.

The CB1200M-MBK is equipped with a large firebox that can accommodate logs up to 18 inches long, allowing users to enjoy extended burn times and consistent heat output. With a capacity of up to 70,000 BTUs, this stove can efficiently heat spaces ranging from 1,000 to 2,200 square feet, making it suitable for a variety of home sizes.

Another standout feature is its advanced air control system, which provides precise control over combustion levels. This system enables users to adjust the air intake to optimize the fire's intensity, ensuring both comfort and efficiency. Additionally, the stove comes with a built-in ash pan, making cleanup easier and enhancing the overall user experience.

The CB1200M-MBK also showcases an appealing aesthetic, featuring a clean, modern design with a traditional cast-iron appearance. The durable, black finish offers an elegant touch, making it a stylish focal point in any room. Moreover, this model is designed to be compatible with various installation options, including top or rear venting, providing flexibility depending on the specific needs of the home.

Durability is another hallmark of the CB1200M-MBK, constructed with high-quality materials that ensure longevity and performance. The heavy-duty steel construction and quality ceramic glass withstand high temperatures and resist cracking, promising years of reliable use.

In conclusion, the Quadra-Fire CB1200M-MBK is a perfect blend of efficiency, performance, and style. With its impressive BTU output, advanced combustion technology, and user-friendly design, it stands as an ideal choice for homeowners looking to enhance their heating solutions while being mindful of environmental impacts.