Quadra-Fire CB1200M-MBK owner manual Listing and Code Approvals

Page 4

CB1200 Pellet Stove

Listing and Code Approvals

R

A. Appliance Certification

E. BTU & Efficiency Specifications

Model

CB1200 Pellet Stove

Laboratory

OMNI Test Laboratories, Inc.

Report No.

061-S-21-4

Type

Solid Fuel Room Heater/Pellet Fuel

 

BurningType

Standard

ASTM E1509-95, ULC S627-M93 and

 

ULC/ORD-C1482-M1990 Room Heater

 

Pellet Fuel Burning type and (UM) 84-

 

HUD, Mobile Home Approved.

State Listing

Colorado, Listed 09-13-05

NOTE: This installation must conform with local codes. In the absence of local codes you must comply with the

ASTM E1509-95, ULC S627-M93, ULC/ORD-C-1482- M1990, (UM) 84-HUD

B. Mobile Home Approved

This appliance is approved for mobile home installations when not installed in a sleeping room and when an outside combustion air inlet is used.

The structural integrity of the mobile home floor, ceiling, and walls must be maintained.

The appliance must be properly grounded to the frame of the mobile home and use only Listed pellet vent Class “L” or “PL” connector pipe.

A Quadra-Fire Outside Air Kit must be installed in a mobile home installation. You must order the Outside Air Kit sepa- rately.

Note: The appliance is also approved for installation into a shop.

C. Glass Specifications

This appliance is equipped with 5mm ceramic glass. Replace glass only with 5mm ceramic glass. Please contact your dealer for replacement glass.

Emissions Rating

0..9 grams/hr

*BTU Output

14,000 - 40,000 / hr

Heating Capacity

up to 2,500 sq. ft. depending

 

on climate zone

Hopper Capacity

80 lbs

Fuel

Wood Pellets or Shelled Corn

Shipping Weight

349 lbs

*BTU output will vary, depending on the brand of fuel you use in your stove. Consult your Quadra-Fire dealer for best results.

WARNING! Risk of Fire! Hearth & Home Technologies disclaims any responsibility for, and the warranty and agency listing will be voided by the above actions.

DO NOT:

Install or operate damaged appliance

Modify appliance

Install other than as instructed by Hearth & Home Technologies

Operate the appliance without fully assembling all components

Overfire

Install any component not approved by Hearth & Home Technologies

Install parts or components not Listed or approved. Improper installation, adjustment, alteration, service or maintenance can cause injury or property damage.

For assistance or additional information, consult a qualified installer, service agency or your dealer.

NOTE: Hearth & Home Technologies, manufacturer of this appliance, reserves the right to alter its products, their specifications and/or price without notice.

D. Electrical Rating

115 VAC, 60 Hz, Start 4.1 Amps, Run 1.1 Amps

NOTE: Some generator or battery back-up systems may not be compatable with the micro-processor elec- tronics on this appliance. Please consult the power supply manufacturer for compatable systems.

Quadra-Fire is a registered trademark of Hearth & Home Technologies.

Page 4

7014-179D

December 16, 2011

Image 4
Contents CB1200M-MBK Hot glass will cause burnsCB 1200 Pellet Stove Testing Lab & Report Number Serial Number Model Mfg Date007C Table of Contents Listing and Code Approvals Getting Started Design, Installation & Location Consider- ationsAppliance Location CB 1200 Pellet Stove Locating Your Appliance & Chimney Negative PressureThermostat Location DraftTools And Supplies Needed CB 1200 Pellet Stove Fire SafetyInspect Appliance & Components and Pre-Burn Check List 3Dimensions and Clearances Appliance DimensionsAlcove Installation CB 1200 Pellet Stove Clearances to Combustibles UL and ULCException for Horizontal Installations CB 1200 Pellet Stove Hearth Pad Requirements UL and ULCChimney and Exhaust Connection 4Vent InformationRVenting Termination Requirements CB 1200 Pellet Stove Equivalent Feet of Pipe Pipe Selection ChartExample of 3 Elbow-Rear Vent Termination Calculaton Venting Systems AlcoveDegree Straight OutCB 1200 Pellet Stove Through The Wall CB 1200 Pellet Stove Vertical into Existing Class a Chimney Vertical Internal Typical InstallationThrough The Wall & Vertical External CB 1200 Pellet Stove Masonry Alternate MasonryMobile Home Floor Installation Rear InstallationAppliance Set-Up Outside Air Kit InstructionsCB 1200 Pellet Stove Top Vent Adapter Installation Rear Vent and Rear Vent to Top Vent Adapter InstallationInstalling the Top Vent Adapter See FigureCB 1200 Pellet Stove Optional Brick Set Installation Brick Clip InstallationInstalling Logo Top Log, LeftRight Front Log Holes. See FigureCB 1200 Pellet Stove Door Installation Thermostat InstallationTo install door To adjust latchesOperating Instructions Fuel Size And Material General Operating InformationFire Characteristics Feed Rate Adjustment InstructionsCB 1200 Pellet Stove Before Your First Fire Starting Your First FireFrequently Asked Questions CB 1200 Pellet Stove Ignition CyclesTroubleshooting SymptomPage Page Types of Fuel Quick Reference Maintenance ChartFrequency Daily Weekly Monthly Cleaning Firepot with Cleaning Rod & Firepot Scraper Cleaning Ash PanCleaning Heat Exchanger Chambers & Drop Tube Ash Removal from FireboxCleaning Beneath Heat Exchanger Cleaning Exhaust PathCleaning the Glass Cleaning the HopperCleaning the Top Vent Adapter Preparing Firebox for Non-Burn Season Frequency YearlyCB 1200 Pellet Stove High Ash Fuel Content Maintenance Convection Blower ReplacementInstall new blower Exhaust Blower Replacement Remove existing blowerRe-install blower to blower housing Replacing Center Glass Replacing Side Glass ScrewsCB 200 Pellet Stove Reference MaterialsComponent Function & Location Vacuum Switch Wiring Harness See .1 belowThermostat Snap Disc #1 Convection Blower 145FCB 1200 Pellet Stove Component Locations CB 1200 Pellet Stove Exploded Views Part number list on followingCB 1200 Pellet Stove Service Parts & Accessories #1 Top Assembly#2 Baffle Assembly Stocked#11 Door Assembly #10 Firepot Assembly and Associated PartsStocked at Depot LVGRL-CB12-BK-B #39 Feed Motor Assembly 39.1 39.8Description Comments Part Number Accessories CB 1200 Pellet Stove Warranty Policy December 16 7014-179D Contact Information

CB1200M-MBK specifications

The Quadra-Fire CB1200M-MBK is a remarkable addition to the lineup of high-efficiency wood stoves, designed to provide exceptional heating performance while maintaining a user-friendly interface and aesthetic appeal. Known for its sleek design and modern technology, the CB1200M-MBK stands out as a powerful solution for both environmentally conscious homeowners and those in search of reliable warmth during cold months.

One of the main features of the CB1200M-MBK is its high efficiency rating, often exceeding 75%. This impressive figure is attributed to its innovative combustion technology, which maximizes wood-burning efficiency by promoting complete combustion. This means more heat is generated from less wood, translating to reduced emissions and less frequent refueling. This efficient design not only benefits the environment but also provides a cost-effective heating solution.

The CB1200M-MBK is equipped with a large firebox that can accommodate logs up to 18 inches long, allowing users to enjoy extended burn times and consistent heat output. With a capacity of up to 70,000 BTUs, this stove can efficiently heat spaces ranging from 1,000 to 2,200 square feet, making it suitable for a variety of home sizes.

Another standout feature is its advanced air control system, which provides precise control over combustion levels. This system enables users to adjust the air intake to optimize the fire's intensity, ensuring both comfort and efficiency. Additionally, the stove comes with a built-in ash pan, making cleanup easier and enhancing the overall user experience.

The CB1200M-MBK also showcases an appealing aesthetic, featuring a clean, modern design with a traditional cast-iron appearance. The durable, black finish offers an elegant touch, making it a stylish focal point in any room. Moreover, this model is designed to be compatible with various installation options, including top or rear venting, providing flexibility depending on the specific needs of the home.

Durability is another hallmark of the CB1200M-MBK, constructed with high-quality materials that ensure longevity and performance. The heavy-duty steel construction and quality ceramic glass withstand high temperatures and resist cracking, promising years of reliable use.

In conclusion, the Quadra-Fire CB1200M-MBK is a perfect blend of efficiency, performance, and style. With its impressive BTU output, advanced combustion technology, and user-friendly design, it stands as an ideal choice for homeowners looking to enhance their heating solutions while being mindful of environmental impacts.