Samsung RF60J9000SL/ML, RF60J9000SG/ML manual Removing the Refrigerator Doors, Setting

When moving your refrigerator

To prevent floor damage, be sure the front leveling legs are in the up position (above the floor).

Refer to “HOW TO LEVEL THE REFRIGERATOR” in the manual on page 23.

REMOVING THE REFRIGERATOR DOORS

If the refrigerator is too large to pass through your doorway easily, you can remove the refrigerator doors.

up

Flooring

For proper installation, you must place this refrigerator on a level, hard surface that is the same height as the rest of the floor.

This surface should be strong enough to support a fully loaded refrigerator.

To protect the finish of the flooring, cut a large section of the cardboard carton and place it under the refrigerator where you are working.

When moving the refrigerator, you need to pull and push it straight forwards or back.

Do not wiggle it from side to side.

For safety reasons, adjust the front side a little higher than the rear side.

Tools you will need (Not provided)			setting
Philips screwdriver	Flat-blade	Socket wrench
(+)	screwdriver (-)	(10 mm)
Pliers	Allen wrench	Allen wrench
	(4 mm)	(5 mm)

•Disconnect power to the refrigerator CAUTION before removing the doors or drawers.

•Be careful not to drop, damage or scratch the doors/drawers while removing them.

•Use care when you remove the doors/drawers. The doors are heavy and you could injure yourself.

•Re-attach the doors/drawers properly to avoid: -- Moisture from air leakage.

-- Uneven door alignment.

-- Wasting energy due to improper door seal.

English - 19

DA68-03194J-04.indb 19 2017. 7. 24.

�� 3:47