Samsung RF60J9000SG/ML, RF60J9000SL/ML HOW to Adjust the Door Height, HOW to Adjust the Door GAP

HOW TO ADJUST THE DOOR HEIGHT

If any one of the doors is lower than the other:

• Check if the Refrigerator is level before adjusting the door.

•Adjust the door height difference by inserting a Snap Ring (1) as shown between the door and the hinge.

You can use the rings on the right side door of the fresh food compartment and both sides of the freezer compartment.

(1)

•After checking the height difference, select one Snap Ring with a suitable thickness. Insert one Snap Ring only, Inserting two or more Snap Rings may cause the Snap Rings to slip out or make a rubbing noise.

•Lift up the lower door and insert the Snap Ring into the space between the Door and the Hinge.

•To avoid injury, insert or remove Snap CAUTION Rings carefully.

•Keep the Snap Rings out of the reach of children and make sure that children do not play with them or put them into their mouths.

•1 mm, 1.5 mm, 2 mm, and 2.5 mm Snap Rings come with the Refrigerator.

•If the Refrigerator is level before you load it with food, the Refrigerator may become unbalanced due to the weight of the food.

If this occurs, adjust the level again using the same procedure.

•If you raise the door too far, it can rub against the Top Cover.

Snap Rings included with the refrigerator:

1 mm 1.5 mm 2 mm 2.5 mm

HOW TO ADJUST THE DOOR GAP

If the gap between the left and right fridge compartment doors is not even.

• You can adjust the gap by turning the bolt at the top right of the cold storage compartment door.

•Do not turn the bolt too far. You can break it.

1.With the doors closed, remove the 3 screws holding the top cover using a Phillips screwdriver, and then lift it off together with the connected cables.

2.Turn the bolt with a 4 mm hexagonal L-wrench to

adjust the gap.

3.Turn the bolt clockwise to ( ) widen the

gap. Turn the bolt counter clockwise ( ) to narrow the gap.

English - 24

DA68-03194J-04.indb 24 2017. 7. 24.

�� 3:47