Samsung LV32F390FIXXRU manual Anynet+ HDMI-CEC is set to On. System → Anynet+ HDMI-CEC

Other Information

Issues	Solutions and Explanations
There is no picture/video.	Check the cable connections. Remove and reconnect all cables connected to the
	product and external devices.
	Set the video outputs of your external devices (Cable/Sat Box, DVD, Blu-ray etc) to
	match the product's input connections. For example, if an external device’s output is
	HDMI, it should be connected to an HDMI input on the product.
	Make sure your connected devices are powered on.
	Be sure to select the correct input source.
	Reboot the connected device by unplugging it, and then reconnecting the device’s
	power cable.
The remote control does not	Replace the remote control batteries. Make sure the batteries are installed with their
work.	poles (+/–) in the correct direction.
	Clean the sensor’s transmission window on the remote.
	Try pointing the remote directly at the product from 1.5~1.8 m away.
The cable/set top box remote	Programme the Cable/Set remote control to operate the product. Refer to the Cable/
control doesn’t turn the	Set-Top-Box user manual for the SAMSUNG product code.
product on or off, or adjust
the volume.
Anynet+ (HDMI-CEC)
Anynet+ does not work.	Check if the device is an Anynet+ device. The Anynet+ system supports Anynet+
	devices only.
	You can connect only one receiver (home theatre).
	Check if the Anynet+ device power cord is properly connected.
	Check the Anynet+ device’s Video/Audio/HDMI cable connections.
	Check whether Anynet+ (HDMI-CEC)is set to On in the Anynet+ setup menu.
	Check whether the product remote control is in product mode.
	Check whether the remote control is Anynet+ compatible.
	Anynet+ doesn’t work in certain situations. (Searching channels, operating Setup,
	etc.)
	If you have removed and then reconnected the HDMI cable, please make sure to
	search devices again or turn your product off and on again.
I want to start Anynet+.	Check if the Anynet+ device is properly connected to the product and check if the
	Anynet+ (HDMI-CEC) is set to On. (System → Anynet+ (HDMI-CEC))
	Open the Tools menu using your remote and then select Anynet+ (HDMI-CEC). Then
	select a menu you want.
I want to exit Anynet+.	Select View TV in the Anynet+ menu.
	Go to Source screen using your remote and select a non-Anynet+ device.
The message Connecting to	You cannot use the remote control when you are configuring Anynet+ or switching to
Anynet+ device ... appears on	a view mode.
the screen.	Use the remote control after the product has completed Anynet+ configuration or
	has finished switching to Anynet+.

English - 77