Pressure Testing Heater Gas Connections
Continued
5.Correct all leaks at once.
6.Light heater (see Operating Heater). Check all other internal joints for leaks.
7.Turn off heater (see To Turn Off Gas Appliance).
Figure 10- Installing Log Set (Top View)
FIG (1)
FIG (5)
STEP 4: Place log 4 on log 1 and log 3, as shown.
Note: Log 4 will contact inside of heater.
Figure 9 - Checking Gas Joints
LOG PLACEMENT
WARNING: Failure to position the parts in accordance with these diagrams or failure to use only parts specifically approved with this heater may result in property damage or personal injury.
FIG (6)
STEP 5: Insert the recessed hole on the bottom of log 5 onto the pin on log 1, with the other end of log 5 placed on log 4, as shown.
FIG (2)
STEP 1: Install log 1 onto the two slots in the rear plate.
CAUTION: After installation and periodically thereafter, check to en- sure that no yellow flame comes in contact with any log. With the heater set to High, check to see if yellow flames contact any log. If so, reposi- tion logs according to the log instal- lation instructions in this manual. Yel- low flames contacting logs will cre- ate soot.
FIG (3)
STEP 2: Install log 2 onto the two slots in the middle plate.
FIG (7)
STEP 6: Place log 6 on log 1 and log 3.
Note: Log 6 will contact inside of heater.
It is very important to install the logs exactly as instructed. Do not modify logs. Only use logs supplied with heater.
Make sure log sits flat on firebox floor.
IMPORTANT: Make sure log does not cover any burner ports (see Figure 10).
FIG (4)
STEP 3: Insert the two pins on the bot- tom of log 3 into the two holes on fire- box floor.
FIG (8)
STEP 7: Insert the recessed hole on the bottom of log 7 onto the pin on log 2, with the other end placed on log 3.
10