OPERATING HEATER
Continued
8.Press BURNER button for desired burner operation.
AUTO: Burner will automatically turn on and off.
MAN: Burner operates continuously.
9.If the appliance will not operate, fol- low the instructions “To Turn Off Gas To Appliance” and call your service technician or gas supplier.
Fig 13 - Front of Remote Control
Fig 15 - Control board
SETTING TIMER
1. AUTO ON:
With burner off, press TIMER button. Then press 
or 
to change to the scheduled time, then press the TIMER button again, the TIMER starts timing and the TIMER will flash and the green operation light flashes. Burner will au- tomatically come on at set time.
2. AUTO OFF:
With burner operating, press TIMER button. Then press 
or 
to change to the scheduled time, then press the TIMER button again, the TIMER starts timing and the TIMER will flash and the green operation flashes. Burner will au- tomatically shut off at set time.
LOCKING REMOTE CONTROL (child proof)
1.Key press locking:
Press LOCK button, a 
symbol will appear on the LCD.
Press ▼, then press LOCK button to unlock.
OPERATING FAN
Press FAN button for desired fan operation.
AUTO: Blower will come on several minutes after burner comes on and will go off several minutes after burner goes off.
MAN: Blower operates continuously.
OFF: Blower is off.
MANUAL OPERATING INSTRUCTIONS
We provide the manual control sys- tem just in case of power shortage. Install battery for Manual Ignitor:
1.Unscrew the ignitor cap.
2.Insert a AAA type battery with its an- ode (“+”) pointing out.
3.Screw the ignitor cap back.
SETTINGTEMPERATURE
With burner is on “Auto” position, press 
or 
to change to the desired temperature.
Fig 14 - Back of Remote Control
(cover removed)
TO TURN OFF GAS 
TO APPLIANCE
Shut off heater
1.Press the IGN/OFF button.
2.Set Switch on OFF position or un- plug the electric power to the heater. (See Figure 12)
SETTING CLOCK
Press CLOCK button for hours or minutes. Press 
or 
for correct time. Press CLOCK button again to set time.
Note: We recommend that the battery be taken out of the ignitor when the power supply gets right.
LIGHTING INSTRUCTIONS 
If power is off, you can operate the fireplace manually.
1.STOP! Read the safety information on page 11.
2.Check that gas supply to heater is on.
3.Open bottom front access panel.
4.Push in gas Control Knob slightly and turn clockwise 
to the OFF position. If Control Knob is on ELEC- TRIC position, press in the Control Knob and turn counterclockwise 
to OFF position.
NOTE: Knob cannot be turned from PILOT/IGN to “OFF” unless knob is pushed in slightly. Do not force.
12