Procom MN100TPA installation manual Specifications, MN060HPA MN100HPA, Parts Under Warranty

Page 17

SPECIFICATIONS

Btu(available) Gas Type Ignition

Pressure Regulator setting

Inlet Gas Pressure* (inches of water) Maximum

Minimum

Dimensions, Inches (HxWxD) Heater

Carton

Weight (pounds) Heater Shipping

MN060HPA

MN100HPA

MN100TPA

6,000

5,500/10,000

10,000

Natural

Only

Natural Only

Natural Only

Piezo

Piezo

Piezo

6" W.C.

6" W.C.

6" W.C.

10.5"

10.5"

10.5"

7"

 

7"

7"

19-1/8 14-1/8 6-3/8

19-1/8×14-1/8×6-3/8

19-1/8×14-1/8×6-3/8

×

×

22 16-3/4 8-1/8

22×16-3/4×8-1/8

22×16-3/4×8-1/8

×

×

12

 

13

13

15

 

16

16

Note: Dimensions listed are outer most points on the heater (includes control knobs and grill). * For purposes of input adjustment.

TECHNICAL SERVICE

You may have further questions about installation, operation, or troubleshooting. If so, contact PRO-COM through phone number 1- 877-886-5989.The information is listed on the front of manual.

REPLACEMENT PARTS

Note: Use only original replacement parts. This will protect your warranty coverage for parts replaced under warranty.

PARTS UNDER WARRANTY

Contact authorized dealer from whom you purchased this product. If they are unable to supply original

SERVICE HINTS

When Gas Pressure Is Too

Low

Pilot will not stay lit

Burner will have delayed ignition

Heater will not produce specified heat

EQUIPMENT SHUTOFF VALVE

For all models. Equipment shutoff valve with 1/8" NPT tap.

replacement part(s), call the num- ber on the front of this manual. When contacting your dealer or PRO-COM, have ready:

your name

your address

model and serial numbers of

 

your heater

how heater was malfunctioning

When Gas Quality Is Bad

Pilot will not stay lit

Burner will produce flames and soot

Heater will backfire when lit

You may feel your gas pressure is too low or the gas quality is poor. If so, contact your local natural gas supplier.

ACCESSORIES

Purchase these heater accesso- ries from your local dealer. If they can not supply these accessories, contact PRO-COM for information. You can also write to the address listed on the front of this manual.

FLOOR MOUNTING STAND

Models MN060HPA,MN100HPA, MN100TPA

For locating heater on the floor away from a wall. Complete installation instructions provided with floor mounting stand.

type of gas used (propane/LP or

 

natural gas)

purchase date

warranty card

Usually, we will ask you to return the defective part to the factory.

PARTS NOT UNDER

WARRANTY

Contact authorized dealers of this product. If they can’t supply original replacement part(s), contact PRO- COM through phone number 1-877-886-5989.

1 7

Image 17
Contents MN060HPA MN100HPA MN100TPA OWNER’S Operation and Installation ManualSafety Information Product Features Providing Adequate Ventilation Fresh AIR for Combustion VentilationDetermining FRESH-AIR Flow for Heater Location Determining if You Have Confined or Unconfined SpaceIng the space of the adjoining AIR for Combustion VentilationVentilation AIR Installation Needs Installation Check GAS TypeVentilation AIR Locating HeaterFastening Heater to Wall Mounting Bracket InstallationRemoving Lower Front Panel Of Heater Methods For Attaching Mounting Bracket To WallPlacing Heater on Mounting Bracket Installing Bottom Mounting ScrewsTypical Inlet Pipe Diameters Connecting to GAS SupplyImportant Install Read Before Lighting NFOR Your SAFETYnOperating Your Heater Checking GAS Connections NTO Turn OFFn MN060HPAGAS to Appliance Shutting Off HeaterRead Before Lighting Operating Your HeaterOperating Heater Cleaning MaintenanceInspecting Burner Observed Problem Possible Cause Remedy TroubleshootingPossible Cause Remedy Observed ProblemHeater produces unwanted odors Parts Under Warranty SpecificationsMN060HPA MN100HPA Models MN060HPA,MN100HPA, MN100TPAMN060HPA Illustrated Parts BreakdownKEY Part NO. Number Parts List MN060HPADescription QTY ODSMN100HPA NRV81FI-6 Parts List MN100HPAKEY Part Number Description QTY MN100TPA Part Description Number QTY Part List MN100TPA