INSTALLATION
Continued
A. MOUNTING HEATER TO WALL
Mounting Bracket
The mounting bracket is located in the package tray (see Figure 9). Remove mounting bracket from tray.
Only use last hole on each end of mounting bracket to attach bracket to wall. These two holes are 16 inches apart from their centers (see Figure 9). Attach mounting bracket to wall studs. This method provides the strongest hold. Insert mounting screws through mounting bracket and into wall studs.
Marking Screw Locations
1.Tape mounting bracket to wall where heater will be located. Make sure mounting bracket is level.
WARNING | Maintain minimum clearances shown |
| |
| in Figure 9. If you can, provide greater |
| clearances from floor and joining wall. |
|
|
2. Mark screw locations on wall (see Figure 9).
Note: Only mark last hole on each end of mounting bracket. Insert mounting screws through these holes only.
3. Remove tape and mounting bracket from wall.
Attaching Mounting Bracket to Wall
|
| Mounting |
|
| Bracket |
��� | ��� |
|
������� |
| |
���� |
|
|
��������� | ���� ������ �������� |
|
|
| |
| ���������� ������������� ������� | ������ |
| ������� |
�����
Figure 9 - Mounting Bracket Clearances Attaching Mounting Bracket To Wall
Note: Mounting screws and spacers are in hardware package. The hardware package is provided with heater.
Attaching To Wall Studs
For attaching mounting bracket to wall studs
1.Drill holes at marked locations using 9/64” drill bit.
2.Place mounting bracket onto wall. Line up last hole on each end of bracket with holes drilled in wall.
3.Insert mounting screws through bracket and into wall studs.
4.Tighten screws until mounting bracket is firmly fastened to wall studs.
NOTE: You may mount the unit anywhere on a concrete wall.
14 | 49D0090 |