ASSEMBLY
INSTALLING LOGS
NOTE: For easier installation, lay heater on its back.
1.Slide screen up to remove.
2.Remove log from inside of base. Discard protective packag- ing.
3.Gently slide log on log retaining pin on base assembly (see Figure 3). The log should fit firmly against bottom of log retaining pin.
4.Place front log in front of burner and behind burner shield.
5.Reattach screen.
Back
Log
Front
Log
| WARNING: Always have burner shield | |
WARNING | and screen in place before operating | |
heater. This prevents excessive | ||
temperatures on heater. | ||
| ||
| Failure to position the parts in | |
| accordance with these diagrams or | |
| failure to use only parts specifically | |
| approved with this heater may result in | |
| property damage or personal injury. | |
|
|
Burner | Pins | |
Figure 3 - Installing Logs | ||
Shield | ||
| ||
| Adjusting |
Side | Plate | Top Brass |
Set | Trim | |
Brass Trim |
| |
Screws |
| |
|
|
Shim
ATTACHING BRASS FRONT TRIM TO
Slot
Slot
FRONT PANEL
If any part or parts are missing, contact dealer where you bought the heater.
Mitered
Edges
Figure 4 - Assembling Bras Trim
1.Remove brass trim from protective packaging. Remove two
(2)
2.Lay trim on the floor face down. Line up the corners with the top trim at the top and the side trims on the sides.
3.Slide one (1)
4.Hold the corners together securely. Tighten screws on both brackets with flat head screwdriver. Make sure the corners are flush and there are no spaces.
5.Repeat steps 2 through 4 for other side trim.
7.Place the assembled trim on front of heater cabinet. Attach on top and sides with four brass screws included in hardware package. See Figure 5.
Assembled
Brass Trim
Screws
Screws
Figure 5 - Attaching Brass Trim to Heater
49D0090 | 7 |