Napoleon Fireplaces BGDV42P, BGDV42N manual Finishing, GDL42 Louvre Installation Logo Placement

19

FINISHING

GDL42 LOUVRE INSTALLATION

LOGO PLACEMENT

UPPERLOUVRE

SLOT

aDOOR LATCH

FIGURES 37

HINGESCREEN

bLOWER LOUVRES (VALVE CONTROL DOOR)

TO INSTALL THE UPPER LOUVRES: Insert the upper louvres into the slots on both brackets.

TO INSTALL THE LOWER

LOUVRE ASSEMBLY: At- tach each hinge to the fire- box with 2 screws.

Position the hinge screen into place and with the con- trol door open, secure to the firebox using three screws.

Remove	the
backing of	the
logo supplied and
place on the glass		½"
viewing door, as
indicated.			LOGO

½"

FIGURE 39

PORCELAIN REFLECTIVE PANELS

1.Remove the upper louvres, and open the glass door. Remove the logs.

2.Remove the securing screw al-

ready in place at the back of the fire- box. If the unit is supplied with a rear log support, remove before install-

L42 LOUVRE INSTALLATION

FIGURE 38

A

B

	UPPER LOUVRES
	Insert the louvre tabs into the
SLOT	slots located at the top left and
	right corners of the unit.
TA B

A

ing the rear panel. Place the rear panel against the back of the firebox

and re-install the rear log support over the panel, if sup- plied. Secure using the original screw.

3.Remove the two securing screws located on either fire- box side.

4.Place the left panel against the left side of the firebox, ensuring that it butts up to the rear panel. Secure in place using 2 of the screws previously removed. Re- peat for the right side.

5.Replace the logs, glass door and louvres.

B

HINGE

CLIP

SLOT

LOWER LOUVRES
Insert the hinge clips into the
slots located at the bottom left
and right corners of the unit.
To remove the louvres, pull the
back tabs of the clips forward,
while pushing the louvre assem-
bly back. Lift the clip.	W415-0381 / C / 05.13.04