Assembly, Unpack the Parts | Vermont Casting 2477CE instruction

Dutchwest Non-Catalytic Convection Heater

Assembly

Your convection heater requires some assembly. Follow the directions carefully and refer to the parts diagram at the back of this manual.

Unpack the Parts

Remove the bottom heat shield strapped to the top of the stove and all loose parts from the ﬁrebox and the ash pan. Check to make sure all the parts are included and intact. You should have received:

•1 fully assembled heater body

•1 bottom heat shield*

•4 legs

•1 ash pan

•1 ceramic handle assembly

•1 hardware bag, containing the following parts:

•(3) #10 x 1/2” sheet metal screws, (to attach the chimney connector to the ﬂue collar)

•(1) 3 mm (1/8”) Allen wrench, (to tighten the door latch)

•(1) 4 mm (5/32”) Allen wrench, (to tighten the damper handle)

•(4) washers, (used with the leg bolts to attach legs to the stove)

•(1) door handle insert holder (for storing the ce- ramic handle assembly when it is not in use.)

•(4) 1/4-20 x 1” hex head screws, (to attach legs)

If any parts are missing or damaged, immediately notify your Dutchwest dealer for replacements. Do not install your stove without having all necessary parts or using damaged parts.

*A Bottom Heat Shield is required in many instal- lations. Refer to the ﬂoor protection information found in the Installation Section of this manual.

Attach the Legs and Heat Shield

NOTE: To avoid damaging the sheet metal compo- nents, do not place the stove on its back to install the legs. Follow the instructions below.

1.Remove the band that holds the stove to the pallet and remove the bottom heat shield that was posi- tioned on top of the stove. (Fig. 15)

2.Rotate the stove counterclockwise until the front left corner overhangs the pallet and the leg-mounting hole is accessible. (Fig. 16)

3.Remove and discard the (4) 1/4-20 x 3/8” hex head bolts that are in the leg holes on the bottom of the stove.

Bottom Heat Shield

ST813

Fig. 15 Remove bands holding stove to pallet and remove heat shield from to of stove.

Leg
Bolt
	Handle Insert
	Holder
	ST814
Fig. 16	Rotate stove on pallet to expose front left corner.

4.In the hardware bag, locate the four legs, the door handle insert holder, (on this leg only, the door handle insert holder is used along with a washer),

(4) 1/4-20 x 1” leg bolts and four (4) washers.

5.Place the bolt through a washer and then the door handle insert holder and align the leg with the bolt hole in the bottom of the stove. Tighten securely.

30003849