Vermont Casting 1990CE Refuel While the Embers are Still Hot, Ash Disposal

ST264

Fig. 26 Add larger pieces of wood as the fire begins to burn

well.

Continue adding split logs of this size to the briskly- burning fire until there is a glowing ember bed at least 76 mm (3”) deep. A good ember bed is neces- sary for proper functioning of the catalytic system and may take an hour or more to establish.

5.Close the damper when the griddle temperature reaches 230° C (450° F).

6.Adjust the air control for your desired heat output.

Refuel While the Embers are Still Hot

Reload the Intrepid II while it is still hot and there are plenty of glowing embers to re-kindle the fire. Include some smaller pieces of wood in the new load of fuel to help the stove rebuild its operating temperature quickly.

Wear stove gloves, and follow this procedure when you reload your stove:

1.Open the thermostat lever.

2.Open the damper.

3.Check the ash level in the ash pan; empty, if neces- sary, and replace the pan.

4.Open the griddle.

5.Position the charcoal in the middle of the firebox (Fig. 41)then load wood — smaller, split pieces first. Increase the amount of fuel you load into the stove as you become familiar with your stove and the heating needs of your home.

NOTE: If the remaining charcoal bed is relatively thick and if your fuel is well seasoned, it is possible to add fresh fuel (smaller pieces first), close the door and damper, and reset the primary air thermostat for the desired heat output.

Do not break the charcoal into very small pieces or pound or compress the charcoal bed.

It is important that air can circulate under the wood for the fire to be quickly revived.

WARNING: Operate your Intrepid II only with the doors either fully open or fully closed.

Intrepid II Woodburning Stove

ST264a

Fig. 27 Add full size logs when the ember bed is 3” (75mm)

deep.

CAUTION: The Intrepid II will be hot while in opera- tion. Keep children, clothing and furniture away. Contact may cause skin burns.

DO NOT OVERFIRE THIS HEATER. Overfiring may cause a house fire, or can result in permanent damage to the stove and to the catalytic combustor. If any part of the Intrepid II glows, you are overfiring.

Ash Disposal

Remove ash before it reaches the top of the ash pan. Check the level at least once a day, and before each re-fueling. If the ash is close to the top edge of the pan, empty it according to this procedure:

1.Open the damper.

2.Open the front doors fully.

3.Using stove gloves, pull the ash pan out of the stove by its handle.

4.Remove the ash pan and properly dispose of the ashes. Be sure to keep the pan level during dispos- al.

5.Return the ash pan to the stove.

Empty the ash pan regularly, typically every one to three days. The frequency will vary depending on how you operate your Intrepid II; if you burn more wood at higher heat output settings, ash will accumulate rapidly.

Remove ash frequently and place it outdoors in a metal container with a tight-fitting lid. Put the closed container of ash on a noncombustible floor or on the ground, well away from all combustible materials, pending final disposal. If the ash is disposed of by burial in soil or otherwise locally dispersed, keep it in the closed con- tainer until all cinders have thoroughly cooled. You can use wood ash as a garden fertilizer.

CAUTION: Never use your household or shop vacuum cleaner to remove ash from the stove; always remove and dispose of the ash properly.

30003840 17