Vanguard Heating Gas Log Heater installation manual Installing, Check GAS Type

INSTALLING
		NOTICE
		A qualified service person must install heater. Follow all local codes.
		NOTICE
		State or local codes may only allow operation of this appliance in a
		vented configuration. Check your state or local codes.
		WARNING
		Before installing in a solid fuel burning fireplace, the chimney flue
		and firebox must be cleaned of soot, creosote, ashes and loose paint
		by a qualified chimney cleaner. Creosote will ignite if highly heated.
		Inspect chimney flue for damage. If damaged, operate heater with
		flue damper closed.
		WARNING
		Seal any fresh air vents or ash clean-out doors located on floor or wall
		of fireplace. If not, drafting may cause pilot outage or sooting. Use a
		heat-resistant sealant. Do not seal chimney flue damper.
		WARNING
		Never install the heater
		• in a bedroom or bathroom unless installed as a vented appli-
		ance (see page 14)
		• in a recreational vehicle
		• where curtains, furniture, clothing, or other flammable objects are
		less than 36 inches from the front, top, or sides of the heater
		• in high traffic areas
		• in windy or drafty areas
		CAUTION
		This heater creates warm air currents. These currents move heat
		to wall surfaces next to heater. Installing heater next to vinyl or
		cloth wall coverings or operating heater where impurities in the air
		(such as tobacco smoke) exist, may discolor walls.
		IMPORTANT: Vent-free heaters add moisture to the air. Although this is benefi-
		cial, installing heater in rooms without enough ventilation air may cause mildew
		to form from too much moisture. See Air for Combustion and Ventilation, pages 5
		through 8.
		CHECK GAS TYPE
		Use only natural gas. If your gas supply is not natural gas, do not install heater.
		Call dealer where you bought heater for proper type heater.
		Continued
	9

103515