®
VENT-FREE GAS RESIDENTIAL HEATERS
ASSEMBLY
Continued
Log
Front Panel
Screen
Truss-
Head
Screw
Nut
Heater Cabinet
Deflector
Log
Retaining
Brackets
5.Slide other end of adjusting plate/shim in slot on mitered edge of side brass trim (see Figure 6).
6.While firmly holding edges of brass trim together, tighten both set screws on the adjusting plate with slotted screwdriver.
7.Repeat steps 1 through 6 for other side.
8.Place the assembled trim on front of heater cabinet. Attach on top and sides with four brass screws included in hard- ware package (see Figure 7).
9.Reattach front panel to heater if you are going to mount the heater to the base. Do not reattach front panel at this time if you are going to mount heater to wall.
Adjusting
PlateTop Brass
Brass Front Trim
Screw
Figure 4 - Assembling Heater
WARNING: Always have burner shield and screen in place before operating heater. This pre- vents excessive temperatures on heater surfaces.
Failure to position the parts in accordance with these diagrams or failure to use only parts spe- cifically approved with this heater
Screw
Brass Front Trim
Screw
Burner Shield
Front Panel
Nut
Trim
Side Brass
Trim Set
Screws
Shim Slot
Slot | Mitered Edge |
Figure 6 - Assembling Brass Trim
Screws
Assembled
Brass Trim
may result in property damage or personal injury.
Attaching Brass Front Trim to Front Panel
1.Locate brass front trim in brass trim package.
2.Slide the head of two
3.Line up screws with holes in front panel (see Figure 4). Insert screws in holes. Attach nuts from inside of front panel. Tighten with wrench.
Figure 5 - Attaching Brass Front Trim to Front Panel
Assembling and Attaching Brass Trim
1.Remove packaging from three remain- ing pieces of brass trim.
2.Locate four brass screws, two adjust- ing plates with set screws, and two shims in the hardware packet.
3.Align shim under adjusting plate as shown in Figure 6.
4.Slide one end of adjusting plate/shim in slot on mitered edge of top brass trim (see Figure 6).
Figure 7 - Attaching Brass Trim to Heater
4 | 104432 |