Harman Stove Company R16 manual ESP Control, Blinks In Igniter Auto. Mode Only Indicates that

Page 16

ESP Control

Mode Selector

Allows you to choose between Room Temp Mode, Stove Temp Mode, or OFF. Also allows you to vary the distribution blower speed by turning the knob to the high or low side of each mode.

Distribution Blower speed adjustment range.

L = low H = high

Variable speed anywhere between L and H; although as the stove temp. goes up, so does the L and H scale.

Igniter switch

Set to appropriate Start-

Up mode.

Test

Runs all motors at full speed for one minute to check operation.

After a minute, the control will simulate a minimum burn and the combustion blower will remain on low.

Feed adjuster

Sets the maximum feed rate

Dealer Diagnostic Port

Temp dial

For dealer maintenance

Allows you to adjust the

only. Requires special DDM

room temperature in Room

monitor supplied to Harman

Temp Mode using the outer

Dealers exclusively.

scale marked in degrees

 

Fahrenheit. It also allows

 

you to adjust the stove

 

temperature while in Stove

 

Temp Mode using the inner

 

scale marked from 1 to 7.

 

Indicates igniter is on.

 

Indicates power to the feed

 

motor.

 

Indicates power to

 

combustion blower

 

Indicates power to

 

distribution blower.

 

Status Light

 

Will be lit in either stove

 

or room temp mode when

 

pointer is not within off

 

position band except after

 

normal shut down. Blinks to

 

indicate errors listed below.

 

Power Light

 

Indicates power to the

 

control.

Status light error messages:

3 Blinks: Indicates that the ESP (Exhaust Sensing Probe) has gone out of range too many times. If the unit seems to be operating correctly, perform a manual reset*.

4 Blinks: Can occur only in Room Temp Mode and indicates Room Sensing Probe failed or not installed. If a Room Sensing Probe is then installed, the status light will automatically reset.

NOTE: Unit will not start in "AUTO" with this status error.

5 Blinks (In Igniter Auto. Mode Only): Indicates that

the unit has failed to light within the 36 minute start cycle. To reset - Turn Mode Selector to "OFF", then turn to either mode again.)

6 Blinks : Indicates that the control has calculated poor or incomplete combustion occurring for more than 50 minutes.

A six blink status may be set if the stove is allowed to run out of pellets. To reset, turn mode selector to "OFF" then back on to the desired mode. If the unit was not out of pellets, see Troubleshooting section, Page 29, for more details.

*Manual reset- disconnect power cord for a few seconds and reconnect. If error still occurs call your Dealer.

16XXV Pellet Stove

Page 15 Page 17
Image 16
Page 15 Page 17
Contents Installation & Operating Manual R16Page Fuel Specifications Fuel and Fuel StorageSerial # Appliance Certification IntroductionModel Assembly and Installation Important NotesInstallation Floor ProtectionAddition, the following must be observed VentingApplies Venting Do not connect to any air distribution duct or systemVent Pipe Avoiding Smoke and Odors Direct Vent Wall Passthrough#1 Preferred method #2 Preferred method#3 Installing into an existing chimney #6 Installing into an existing chimney US and Canada #8 Installing through the ceiling Minimum flue vent configuration Vent ConfigurationsBlinks In Igniter Auto. Mode Only Indicates that ESP ControlLow Draft Voltage Adjustment Low Draft Voltage AdjustmentRoom Temperature Mode Automatic IGNITION/OPERATIONFeed Adjuster Knob Stove Temperature ModeShut Down Procedure Turn Feed Adjuster to #4.4 Automatic Start UPStove Temperature Mode Room Temperature ModeManual IGNITION/Operation Manual Start UP Igniter Switch to Manual up positionFill the hopper with pellets and remove ashes as required.1 Room Sensor Installation Room sensor InstallationCleaning MaintenanceRemoving Ashes ESP Burn Pot Cleaning and Maintenance Maintenance Burn PotNot coiled inside the burn pot Viewing Glass Options XXV Top Flue OptionDirect Vent Wall Passthrough HarmanTrouble-Shooting Cleaning Burn PotHelpful Hints FuelSpecifications Wiring DiagramXXV Pellet Stove Limited Lifetime Warranty Hearth & Home Technologies IncWarranty Conditions This warranty is void ifOperation in Room Temp mode Operation in Stove Temp modeChanges to Maintenance Schedule Service Parts ActiveRetired units Part number list on followingAt depot StockedStocked at depot No longer availableXXV Pellet Stove #44 Feeder assembly Post Serial number StockedHardware Packages Service & Maintenance Log Service & Maintenance Log Page Signature of Boxer Proudly Printed On 100% Recycled Paper

R16 specifications

The Harman Stove Company R16 is a testament to innovative design and efficiency in the world of heating solutions. Built to provide both comfort and style, this stove stands out with its blend of traditional appeal and modern technology.

One of the key features of the R16 is its impressive heating capacity. It is designed to effectively warm up medium to large spaces, making it an ideal choice for homes and cabins alike. With a high BTU output, the R16 optimizes fuel use while distributing heat uniformly, ensuring the entire area remains cozy even in the coldest months.

Another highlight of the R16 is its advanced combustion technology. The stove incorporates a clean-burning system that not only maximizes efficiency but also reduces emissions. This environmentally friendly approach aligns with the growing commitment to sustainability in heating solutions. The R16 can burn a variety of fuels, including wood, making it versatile and convenient for different users.

The design of the R16 also supports ease of use and maintenance. It features a user-friendly control panel, allowing owners to adjust settings effortlessly. Additionally, the stove is equipped with a large glass door, providing an unobstructed view of the flames and enhancing the ambiance of any room.

Durability is another characteristic of the R16. Constructed with high-quality materials, this stove is built to last. The cast iron body ensures excellent heat retention, while the elegant finish complements a variety of interior styles.

Safety is paramount in the design of the Harman R16. It comes with built-in safety features, including a heat shield and an effective flue system that minimizes the risk of overheating and ensures safe operation.

In conclusion, the Harman Stove Company R16 combines cutting-edge technology, efficiency, and aesthetic appeal. With its powerful heating capabilities, clean combustion system, ease of use, and robust design, it stands out as a leading choice for those seeking a reliable and stylish heating solution for their spaces. The R16 not only provides warmth but also enhances the overall experience of a home, making it a worthy investment for any homeowner.
Top Page Image Contents