Venting, Applies | Harman Stove Company R16 specs

Venting

Requirements for Terminating the Venting WARNING: Venting terminals must not be recessed into a wall or siding.

NOTE: Only the Harman Direct Vent Wall Pass-through (part # 1-00-677077) or PL listed vent pipe wall pass- throughs and fire stops should be used when venting through combustible materials.

NOTE: Always take into consideration the effects of the prevailing wind direction or other wind currents that may cause flyash and/or smoke when placing the termination vent.

In addition, the following must be observed:

A. The clearance above grade must be a minimum of 18".1

B. The clearance to a window or door that may be opened must be a minimum of 48" to the side, 48" below the window/door, and 12" above the window/door.1(with outside air installed, 18” to side or below window/door) C. A 12" clearance to a permanently closed window is recommended to prevent condensation on the window. D. The vertical clearance to a ventilated soffit located above the terminal within a horizontal distance of 2 feet (60 cm) from the center-line of the terminal must be a minimum of 18".

E. The clearance to an unventilated soffit must be a minimum of 12".

F. The clearance to an outside corner is 11" from center of pipe.

G. The clearance to an inside corner is 12".

H.A vent must not be installed within 3 feet (90 cm) above a gas meter/regulator assembly when measured from the horizontal center-line of the regulator.1

I.The clearance to service regulator vent outlet must be a minimum of 6 feet.1

J. The clearance to a non-mechanical air supply inlet to the building or the combustion air inlet to any other appliance must be a minimum of 48”.1

K. The clearance to a mechanical air supply inlet must be a minimum of 10 feet.1

(with outside air installed, 6 feet )

L. The clearance above a paved sidewalk or a paved driveway located on public property must be a minimum of 7 feet.1,2

M. The clearance under a veranda, porch, deck or balcony must be a minimum of 12 inches.1,3(B. Also

Applies)

NOTE: The clearance to vegetation and other exterior combustibles such as mulch is 36” as measured from the center of the outlet or cap. This 36” radius continues to grade or a minimum of 7 feet below the outlet.

1Certain Canadian and or Local codes or regulations may require different clearances.

2A vent shall not terminate directly above a side- walk or paved driveway which is located between two single  family dwellings and serves both dwellings.

3Only permitted if veranda, porch, deck, or balcony is fully open on a minimum of 2 sides beneath the floor.

NOTE: A chimney connector may not pass through an attic or roof space, closet or similar concealed space, floor, or ceiling.

NOTE: Where passage through a wall, or partition of combustible construction is desired, the installation shall conform to CAN/CSA-B365. (if in Canada)

= Vent terminal

= Air supply intake

= Area where vent terminal not permitted

8 XXV Pellet Stove

R16 specifications

The Harman Stove Company R16 is a testament to innovative design and efficiency in the world of heating solutions. Built to provide both comfort and style, this stove stands out with its blend of traditional appeal and modern technology.

One of the key features of the R16 is its impressive heating capacity. It is designed to effectively warm up medium to large spaces, making it an ideal choice for homes and cabins alike. With a high BTU output, the R16 optimizes fuel use while distributing heat uniformly, ensuring the entire area remains cozy even in the coldest months.

Another highlight of the R16 is its advanced combustion technology. The stove incorporates a clean-burning system that not only maximizes efficiency but also reduces emissions. This environmentally friendly approach aligns with the growing commitment to sustainability in heating solutions. The R16 can burn a variety of fuels, including wood, making it versatile and convenient for different users.

The design of the R16 also supports ease of use and maintenance. It features a user-friendly control panel, allowing owners to adjust settings effortlessly. Additionally, the stove is equipped with a large glass door, providing an unobstructed view of the flames and enhancing the ambiance of any room.

Durability is another characteristic of the R16. Constructed with high-quality materials, this stove is built to last. The cast iron body ensures excellent heat retention, while the elegant finish complements a variety of interior styles.

Safety is paramount in the design of the Harman R16. It comes with built-in safety features, including a heat shield and an effective flue system that minimizes the risk of overheating and ensures safe operation.

In conclusion, the Harman Stove Company R16 combines cutting-edge technology, efficiency, and aesthetic appeal. With its powerful heating capabilities, clean combustion system, ease of use, and robust design, it stands out as a leading choice for those seeking a reliable and stylish heating solution for their spaces. The R16 not only provides warmth but also enhances the overall experience of a home, making it a worthy investment for any homeowner.