Maintenance
Pellet fines will accumulate in the feeder body over a period of time; therefore, a yearly inspection and cleaning of this must be performed.
To clean out fines:
1.Remove right rear cover panel.
2.Remove wing nut and feeder cover on the right side of the feeder. See Fig. 43.
3.Use a vacuum cleaner to remove all fines.
4.Reinstall feed cover, wing nut, and right rear cover panel.
Two 5/16" socket hex screws on each side.
Fig. 42
Feeder cover gasket
Feeder cover
Wing
Nut
Pellet Fines will build | Fig. 43 |
up in this area | |
|
|
| Viewing Glass |
|
|
The glass in your Harman stove is a special ceramic glass.
•Do not abuse the glass by striking or slamming the door.
•Never burn the appliance if the door glass is cracked or broken.
•Replace only with Harman supplied 5mm ceramic glass.
Soot and/or
Glass replacement
Carefully remove all remaining glass and gasket materials prior to replacing the glass.
Lay the door face down on a flat surface. Remove the glass retainers and screws. Apply the gasket material to the face of the new glass. Lay the glass into the door, making sure that the glass is contained within
the channels and raised areas of the door itself. Lay the glass retainers into position and install the screws. Tighten each screw evenly to avoid making any stress points.
Gasket
Glass
Screws &
Retainers
XXV Pellet Stove 27